Markus Rechberger wrote:
Hi John,
...
can you give us more information about that? The Xceive
firmwarepackage contains extra firmwares for Australia, it would be
good to directly focus on the specific difference instead of passing
eg. a countrycode to a dvb driver (this shouldn't be an
Hi John,
On 5/12/07, John Newbigin [EMAIL PROTECTED] wrote:
Markus Rechberger wrote:
Anyway do you know the exact difference between DVB-T in Australia and
other countries?
I can answer that. AS4599 and AS4933 are the standards for DVB-T in
Australia. It is basically ETSI standard DVB-T.
On 5/12/07, System Administrator [EMAIL PROTECTED] wrote:
On Sat, 2007-05-12 at 03:23 +0200, Markus Rechberger wrote:
Regarding the firmware I believe that
for Australia we should be able to use any xc3028 firmware which will
work with
the board by appending, minus the first byte, my
Markus Rechberger wrote:
Anyway do you know the exact difference between DVB-T in Australia and
other countries?
I can answer that. AS4599 and AS4933 are the standards for DVB-T in
Australia. It is basically ETSI standard DVB-T. It defines the
meanings of content descriptors and ratings
Markus Rechberger wrote:
The problem is that we have no documentation about specific settings
for your device. Daniel just took the firmware which he captured from
the USB bus, which is the easiest solution to get a step forward. Next
step would be to ask Dvico if they could send us the
Hi all,
I previously posted a patch for v4l-dvb-experimental based on Roger's
work which provided partial support for the Dual Digital 4 in Australia.
After a lot of investigation and experimentation, I have been able to
greatly improve the patch such that it provides the same level of
Hi Daniel,
On 5/11/07, System Administrator [EMAIL PROTECTED] wrote:
Hi all,
I previously posted a patch for v4l-dvb-experimental based on Roger's
work which provided partial support for the Dual Digital 4 in Australia.
After a lot of investigation and experimentation, I have been able to
--- System Administrator [EMAIL PROTECTED] wrote:
I am still experiencing problems with
SBS (UHF channel 36, 585.625MHz) which, as before, could be caused by
either the set_frequency offset or bad signal quality.
Hi Daniel,
Can you confirm you need the extra 125kHz offset from the centre
On 5/12/07, [EMAIL PROTECTED] [EMAIL PROTECTED] wrote:
--- System Administrator [EMAIL PROTECTED] wrote:
I am still experiencing problems with
SBS (UHF channel 36, 585.625MHz) which, as before, could be caused by
either the set_frequency offset or bad signal quality.
Hi Daniel,
Can you
Can you confirm you need the extra 125kHz offset from the centre frequency
regarding the specs the different offset is needed for that version of
the firmware.
I'll implement it within the next 1-2 hours though :-)
Markus
Hi Markus,
Is the extra 125kHz offset band specific or
On 5/12/07, [EMAIL PROTECTED] [EMAIL PROTECTED] wrote:
Can you confirm you need the extra 125kHz offset from the centre frequency
regarding the specs the different offset is needed for that version of
the firmware.
I'll implement it within the next 1-2 hours though :-)
Markus
Hi
On Sat, 2007-05-12 at 03:23 +0200, Markus Rechberger wrote:
Regarding the firmware I believe that
for Australia we should be able to use any xc3028 firmware which will work
with
the board by appending, minus the first byte, my xc3028.au.fw file to the
7MHz
firmware file and using
12 matches
Mail list logo
