And currently the temperature alarming is very, very broke.
We have a situation where we have many temperature sensors sharing a
onewire bus with many other sensors, for which we're already using
alarming (total of ~40-70 sensors per bus; collection of 2406, 18B20,
and 2450). We'd like to use
On Mon, Apr 28, 2008 at 1:10 PM, Jim Kusznir [EMAIL PROTECTED] wrote:
And currently the temperature alarming is very, very broke.
This is the first report on this problem. Can you tell me more?
Looking through the data sheet (
http://datasheets.maxim-ic.com/en/ds/DS18B20.pdf) the alarm
Hello!
Paul, all of this discussion surrounding issues for the DS2413 reminds me of
the problems I had earlier for the DS2423 device.
Would it be safe to state that support for that gizmo is firmly installed in
the latest release, (both numbered and available as a download, and from
CVS) for our
Paul Alfille wrote:
Have you seen my report about the cvs and DS2413?
Yes, can you test again?
Sorry I've been busy in the last couple of days.
I'm going to test it in the next few minutes but tell me one thing:
where should I read the current status of the switches? PIO.A/B or
Reading:
Latch shows what you set
PIO shows what it senses (only useful if switch is off).
On Mon, Apr 28, 2008 at 5:38 PM, Alessio Sangalli [EMAIL PROTECTED]
wrote:
Paul Alfille wrote:
Have you seen my report about the cvs and DS2413?
Yes, can you test again?
Sorry I've been busy
The DS2423 works.
On Mon, Apr 28, 2008 at 4:25 PM, Gregg C Levine
[EMAIL PROTECTED] wrote:
Hello!
Paul, all of this discussion surrounding issues for the DS2413 reminds me
of
the problems I had earlier for the DS2423 device.
Would it be safe to state that support for that gizmo is firmly
Paul Alfille wrote:
Reading:
Latch shows what you set
PIO shows what it senses (only useful if switch is off).
Ok. So, the report is, I cannot *set* any value with CVS version...
writing 0 or 1 to PIO.A/B does not change the status of the device.
2.7p4 works fine.
bye
Alessio
