[Repeater-Builder] Link-Comm - Micor carrier squelch timing (was GE squelch)

Bob, et al, Bob wrote: FWIW, I never use pin 10 at all; Kevin wrote: I try to use that pin when I can, and prefer it over the open emitter shunt switches. Incidentally, the Link-Comm board uses the 2.2 uF cap / pin 10 combination to drive the COS output buffer... FWIW Bob

Re: [Repeater-Builder] Link-Comm - Micor carrier squelch timing (was GE squelch)

I will see if I can perform that test on Monday AM and post the results. BTW, the typical propogation delay through all the controllers is less that 5mS, so pretty fast. Allan Overcast KF7FW Link Communications, Inc. www.link-comm.com Kevin Custer [EMAIL PROTECTED] wrote:

Re: [Repeater-Builder] Link-Comm - Micor carrier squelch timing (was GE squelch)

At 1/28/2007 07:26, you wrote: I will see if I can perform that test on Monday AM and post the results. BTW, the typical propogation delay through all the controllers is less that 5mS, so pretty fast. ..except the RLC-3 RLC-4, unless there's been very recent firmware upgrades that have taken

Re: [Repeater-Builder] Link-Comm - Micor carrier squelch timing (was GE squelch)

Thank you... (this is very interesting to me) Kevin Custer Allan Overcast wrote: I will see if I can perform that test on Monday AM and post the results. BTW, the typical propogation delay through all the controllers is less that 5mS, so pretty fast. Allan Overcast KF7FW Link