Hello Andrey. I will still need two 10353 boards for each camera? It means I will need 6 boards for all the project.
Regards, Yakov. On Fri, Aug 21, 2015 at 11:56 PM, support-list < support-list@support.elphel.com> wrote: > Hello Yakov, > > Running KAI11002 at higher pixel rate decreases the dynamic range, and the > Model 323 was designed to provide full dynamic range that sensor can > provide while the required frame rate for book scanning was just 1 frame > per 1.5 second. All the timing of the CCD is implemented in the FPGA so it > is possible to increase the frame rate (you will also need to replace 10313 > boards with 10353 as the older AXIS CPU had limited network bandwidth due > to software checksum calculation). On the other hand, reducing the dynamic > range by increasing the frame rate would reduce advantage of that CCD image > sensor and you will get performance of the newer CMOS image sensors that > are much easier to operate. > > Andrey > > ---- On Fri, 21 Aug 2015 09:03:48 -0700 *Yakov <queila...@gmail.com > <queila...@gmail.com>>* wrote ---- > > Hello. I have one question. It's mentioned in that model 323 can only > shoot 2 fps. But it's matrix can do 4.8 fps at 30mhz. Can model 323 can be > somehow upgraded to do 4.8 fps? > > Best regards, > Yakov Petrov. > _______________________________________________ > Support-list mailing list > Support-list@support.elphel.com > http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com > > > >
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com