** Also affects: fedora
Importance: Undecided
Status: New
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1883336
Title:
Dell Precision 7730, sig=0x906ea/20200609, System hangs when
I got in contact with the e1000e driver maintainers. After trying some
of there suggestions, it looks like a case of bad HW. Thanks for your
help.
** Changed in: linux (Ubuntu)
Status: Confirmed = Invalid
--
You received this bug notification because you are a member of Ubuntu
Bugs,
I am including Karsten's response for the record here. I sent him some
additional info (recorded above), but have not heard back.
Hi Mark,
Am 03.11.2012 03:05, schrieb Mark Bidewell:
I have a DP35DP mainboard with the 82566DC-2 onboard NIC. I installed
Ubuntu 12.04 with Kernel 3.2. At some
Unfortunately the modprobe fix turned out to be a mirage, and the card
stopped working after the computer had been shutdown
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1072722
Title:
8086:294c
Some more observations working on the Issue, when the NIC is working
lspci reports it has the bus master flag, MSI is enabled, and IRQ
typically 46. When not working lspci reports no busmaster, MSI is
disabled, and IRQ is 20. Syslog always reports e1000e looking at IRQ
46. In the failure case,
Ran some more tests. After noting the BIOS setup correlation, I
replaced the BIOS battery and reflashed the the BIOS. This did not
appear to have any effect.
I just tried creating a modprobe conf file with alias eth0 e1000e.
After a reboot the NIC was back and functioning.
--
You received
I have gotten in contact with Karsten and sent him some data. I took
lspci and syslog snapshots in both working and nonworking condition and
there are differences which may prove enlightening so I am including it
here.
** Attachment added: lspci in the nonworking state
** Attachment added: lspci in the working state
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1072722/+attachment/3422731/+files/working_lspci.txt
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
** Attachment added: Syslog in the nonworking state
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1072722/+attachment/3422732/+files/nonworking_syslog.txt
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
** Attachment added: Syslog in the working state
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1072722/+attachment/3422733/+files/working_syslog.txt
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
I have attempted to reach out to Karsten. Unfortunately @suse.de is not
longer valid. I will update if/when I hear back. What is clear is that
this problem is hardware related due to the fact that reverting to an
older/working kernel does not fix it. What is unclear is if a kernel
bug created
Thanks, I will do that. I was looking in launchpad to see if there were
any similar bugs. Number 1014490 mentions in the comments that the
SuperMicro Tech Support suggest a EEPROM flush.
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to
I have tried to reproduce this with Lucid which had worked correctly,
but that exhibited the same bug. My only conclusion is that this is a
hardware failure.
** Changed in: linux (Ubuntu)
Status: Incomplete = Invalid
--
You received this bug notification because you are a member of
** Changed in: linux (Ubuntu)
Status: Invalid = Incomplete
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1072722
Title:
8086:294c Intel NIC driver e1000e not claiming HW
To manage
I did a little more research and there were cases in the past where
e1000e could cause a HW failure so I don't know if this is invalid or
not.. It appears that in the 2.6.27 series there were bugs in the
e1000e driver which could corrupt its EEPROM. Could this bug have
resurfaced? If I go into
Public bug reported:
The intel e100e driver does not appear to be claming a intel 82566DC-2
NIC. It was working fine until sometime post 12.04.1. 12.10 also
exhibits this behavior. The RealTek Wireless I installed as a backup
works fine. I built the latest Intel driver but it exhibited the same
Adding additional logging from lshw
** Attachment added: NICBug.txt
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/1072722/+attachment/3417578/+files/NICBug.txt
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
Unfortunately, I cannot pinpoint the exact kernel, I went back and tried
a 12.04.1 LiveCD and the bug was there so I could be mistaken when it
first exhibited. It happened once a few weeks ago a reboot brought it
back, then this week eth0 disappeared and has only sporadically
returned. What I
I am seeing this issue as well with an intel 82566DC-2 NIC. It was
working fine until sometime post 12.04.1. 12.10 also exhibits this
behavior. The RealTek Wireless I installed as a backup works fine. I
built the latest Intel driver but it exhibited the same problems
** Attachment added:
*** This bug is a duplicate of bug 956677 ***
https://bugs.launchpad.net/bugs/956677
I just found another bug covering this here:
https://bugs.launchpad.net/ubuntu/+source/bcmwl/+bug/945257
Apologies for the duplicate.
** This bug has been marked a duplicate of bug 956677
Live CD boot
Whoops, accidentally changed the status of the bug. Can it be changed
back?
** Changed in: linux (Ubuntu)
Status: Triaged = Confirmed
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/950295
Public bug reported:
When I attempt to install Ubuntu/Kubuntu 12.04 Beta 2 on a laptop with a
b43 miniPCI wireless card, then system hard locks on boot when
attempting to load the network drivers. Using the alternate installer I
can install but the resulting install will not boot with the same
I updated and as you suspected the problem is resolved, should have done
that first.
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/934199
Title:
Display Resolution set in KDE System Settings is not
Public bug reported:
I am running Kubuntu 12.04 Alpha 2. When I set the display resolution
in System Settings, it works fine however, when I reboot, the resolution
reverts to 640x480. This is using VMWare Fusion 4. I have run Fedora
16 KDE in the same VMWare without this issue.
** Affects:
One other thing I might add, I noticed Mesa 8.0 is in Precise. There
has been a lot of talk on Phronix and other blogs about Mesa 8.0 and
the llvmpipe driver which can be used for software rendering on non-
accelerated HW. Fedora 17 plans on using llvmpipe to allow gnome-shell
on
To add to this, I saw this issue in VMWare Fusion. Most windows were
not drawing properly. It seemed to me that Ubuntu was attempting to
load Unity 3D on non-accelerated HW. Explicitly choosing Ubuntu 2D at
login fixed the issue.
--
You received this bug notification because you are a member
Public bug reported:
When Using Unity 5.x, the Ubuntu Desktop menu does not display when
flying over the top bar. All other applications work as they should.
** Affects: unity (Ubuntu)
Importance: Undecided
Status: New
--
You received this bug notification because you are a
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/851462
Title:
[i915gm] False GPU lockup EIR: 0x0010 PGTBL_ER: 0x0100
render.IPEHR: 0x0204
To manage notifications about this bug go to:
Public bug reported:
Error seems to occur on login
ProblemType: Crash
DistroRelease: Ubuntu 11.10
Package: xserver-xorg-video-intel 2:2.15.901-1ubuntu2
ProcVersionSignature: Ubuntu 3.0.0-11.18-generic 3.0.4
Uname: Linux 3.0.0-11-generic i686
.tmp.unity.support.test.0:
ApportVersion:
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/850512
Title:
Garbage pixels in unity 2D
To manage notifications about this bug go to:
Here is a screenshot showing the issue.
** Attachment added: Screenshot at 2011-09-14 20:15:04.png
https://bugs.launchpad.net/ubuntu/+source/unity/+bug/850512/+attachment/2405343/+files/Screenshot%20at%202011-09-14%2020%3A15%3A04.png
--
You received this bug notification because you are a
Public bug reported:
In Unity 2D there are some garbage pixels on the top of the upper bar
primarily on the upper right. Unity 3D does not have this issue.
ProblemType: Bug
DistroRelease: Ubuntu 11.10
Package: unity-services 4.14.2-0ubuntu2
ProcVersionSignature: Ubuntu 3.0.0-11.18-generic 3.0.4
*** This bug is a duplicate of bug 828684 ***
https://bugs.launchpad.net/bugs/828684
Public bug reported:
This issue occurs reliably on login.
ProblemType: Crash
DistroRelease: Ubuntu 11.10
Package: xserver-xorg-video-intel 2:2.15.901-1ubuntu2
ProcVersionSignature: Ubuntu
*** This bug is a duplicate of bug 828684 ***
https://bugs.launchpad.net/bugs/828684
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/847228
Title:
[i915gm] False GPU lockup EIR: 0x0010
I have encountered this with Lubuntu as well. Effects worked fine on
Ubuntu 10.04 LTS
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/636425
Title:
compositing doesn't work [intel]
--
ubuntu-bugs
Will this xorg update be made available as a normal update for 10.04?
--
quadrapassel doesn't start: Failed to initialise clutter: Unable to select the
newly created GLX context
https://bugs.launchpad.net/bugs/561734
You received this bug notification because you are a member of Ubuntu
Bugs,
I reported this on the fedora-devel mailing list as well. Here is a
link to the thread:
http://lists.fedoraproject.org/pipermail/devel/2010-April/134957.html
For those having issues with nouveau, are there any optional Mesa
packages in Ubuntu similar to that referenced in the thread?
--
I just tried Fedora 13 Beta in KVM and received the same error. Fedora
13 on my real HW (Geforce 8600GTS) works
--
quadrapassel doesn't start: Failed to initialise clutter: Unable to select the
newly created GLX context
https://bugs.launchpad.net/bugs/561734
You received this bug notification
I have tried on VirtualBox and KVM (graphics set to VMWare and std)
--
quadrapassel doesn't start
https://bugs.launchpad.net/bugs/561734
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
As an FYI my tests were with VirtualBox and Qemu-KVM
--
quadrapassel cannot load
https://bugs.launchpad.net/bugs/552134
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
Public bug reported:
Binary package hint: gnome-games
When attempting to load quadrapassel in Lucid the errors:
failed to create drawable
Failed to initialise clutter: Unable to select the newly created GLX context
Are displayed and quadrapassel will not load. Glxgears runs fine.
** Attachment added: Dependencies.txt
http://launchpadlibrarian.net/42560902/Dependencies.txt
--
quadrapassel cannot load
https://bugs.launchpad.net/bugs/552134
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing
42 matches
Mail list logo
