Seems that this is now fixed with the Intrepid release. Closing this
one off.
** Changed in: linux (Ubuntu)
Status: Triaged = Fix Released
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of
I finally have been able to test my previous configuration as asked(with a
little delay).
More less the same config:
- Same hard drive (2.5 Samsung M60/120GO linked to the mobo with an adaptator
2.5/3.5, but the disk is not the same but a brand new one)
- Same motherboard
- Processor is an
The Ubuntu Kernel Team is planning to move to the 2.6.27 kernel for the
upcoming Intrepid Ibex 8.10 release. As a result, the kernel team would
appreciate it if you could please test this newer 2.6.27 Ubuntu kernel.
There are one of two ways you should be able to test:
1) If you are comfortable
hi,
Thanks for this information.
Nevertheless there is little chance this applies to me.
My disk is always connected alone as a master disk to a single master cable 3.5
to 2.5 inch(my disk is a laptop disk in a desktop computer). I enclose the pic
of the cable.
It's whether a udma1 conroller
Hi Saivann
After a few tries, you assumptions were right. I can boot on pata 2ndary
channel but not on the 1st channel. Strange cauz my plextor cdrw drive.
Althought Win works on both channels, i guess my MB ide controllers seem to
have a transfer data rate problem.
Mb is a low cost asrock
** Description changed:
Binary package hint: usplash
I upgraded from gusty to Hardy yesterday the installation went fine and
asked me to reboot which i did but since it failed to reboot.
My desktop computer:
CM asrock k7NF2-vsta Raid (chipset nforce2)
Athlon 1800+
Memory:
Excellent, thanks for that information. This bug might be a
misconfiguration problem which was tolerated by Gutsy but not Hardy. If
your hard drive is the only one device on the primary PATA cable, it
must be connected to the last connector (channel) of the PATA cable and
the jumpers must be set
I tried to boot on ubuntu and it finally booted!!
Changes made since:
- replaced 1x512 mo by 2X256mo in dual channel
- Tried 2ndary ide channel instead of 1st;(bios)
- enabled once the sata chip (bios) but turned it off again, and it still boots
perfect.
But the disk i boot on is still the same
parislanuit: This is interesting! Can you try to find which one cause
Hardy to fail? I suspect that it is the 1st IDE channel.
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is
Some additional info about my HDD
** Attachment added: ScreenShot001.png
http://launchpadlibrarian.net/14589573/ScreenShot001.png
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs,
** Attachment added: ScreenShot003.png
http://launchpadlibrarian.net/14589593/ScreenShot003.png
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
** Attachment added: ScreenShot004.png
http://launchpadlibrarian.net/14589595/ScreenShot004.png
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
Looks liuke there is a problem to disk's driver and/or cable 2.5' to
3.5'even under win...
if this may help!
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to
Thanks to you i will keep the partition like this for a few days in case
theyneed further tests/info.
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
** Attachment added: version.log
http://launchpadlibrarian.net/14250326/version.log
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs
Thanks.
I finally burnt a genuine Ubuntu desktop liveCD and booted on it to issue these
files as requested:
** Attachment added: dmesg.log
http://launchpadlibrarian.net/14250273/dmesg.log
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this
** Attachment added: uname-a.log
http://launchpadlibrarian.net/14250303/uname-a.log
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs
Thank you very much. I set status to Triaged, Importance to High and I
assign the bug to the ubuntu-kernel-team. I can't do anything else to
help this bug report but since it now contains necessary informations,
developers will be able to take a look at it and to ask questions if
needed. Thanks
** Changed in: linux (Ubuntu)
Sourcepackagename: usplash = linux
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
According to the outputs that you get, that really sounds like a Hard
drive which has bad blocks. Can you scan your hard drive for bad blocks
using this command?
sudo badblocks -sv /dev/sda
or
sudo badblocks -sv /dev/hda
depending if your Hard drive appears as /dev/hda or /dev/sda
This will do
I forgot to mention that you can do this from the LiveCD, since your are
not able to boot your computer.
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
Many Thanks Saivann for helping.
I just carried out the hard drive as u suggested but i fear we went
wrong as the test didn t find any da;aged cluster:
Quote/
[EMAIL PROTECTED]:~$ sudo badblocks -sv /dev/sda
badblocks: No such file or directory while trying to determine device size
[EMAIL
Thanks for your confirmation. Then we have to assume that there is a
problem with ubuntu. I personally have no idea about how it can be
fixed. To help Linux kernel team, can you boot with the LiveCD and
attach the files created by these commands to that bug report?
* uname -a uname-a.log
** Attachment added: lspci-vvnn.log
http://launchpadlibrarian.net/14231054/lspci-vvnn.log
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
** Attachment added: uname-a.log
http://launchpadlibrarian.net/14231066/uname-a.log
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs
Thanks for ur reply anyway and for the assistance.
I of course enclose the attachements to help the team.
I d have loved to be more helpful but i lack knozledge on this.
Do not hesitate to co;e back if y need or onyone needs ;ore details or
reports. wont refor;at bynow. will use zin as a
There is no version_signature file but a version file at that place.
But it only creates an empty file
nb I am using a drepper drake liveCD..
** Attachment added: version.log
http://launchpadlibrarian.net/14231246/version.log
--
Not booting after upgrade to Hardy Heron
** Attachment removed: uname-a.log
http://launchpadlibrarian.net/14231066/uname-a.log
** Attachment removed: version.log
http://launchpadlibrarian.net/14231246/version.log
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug
Thanks for your fast answer and for the informations you provide. Can
you actually provide dmesg, uname-a and version.log when booting from
Hardy LiveCD? These logs need you to boot from the version of ubuntu
which has the issue.
Also since Gutsy worked correctly with your computer, I think that
No problem u Ubuntu Teams can rely upon my support/assistance if
required.
Can these logs be issued from a hardy Xubuntu alternate cd(xfce) or it
has to be done from the ubuntu LiveCD only?
Brgds
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received
Xubuntu, Kubuntu or Ubuntu can be used. Since the problem is with Hardy
release, logs need to be created from Hardy (specially dmesg if you can)
but if you can't even boot the {X,K}ubuntu LiveCD, What we have now will
be enough, I think.
--
Not booting after upgrade to Hardy Heron
** Attachment added: video of the boot failure(recovery mode)
http://launchpadlibrarian.net/14201592/bughardyheron.avi
--
Not booting after upgrade to Hardy Heron
https://bugs.launchpad.net/bugs/226558
You received this bug notification because you are a member of Ubuntu
Bugs, which is
32 matches
Mail list logo
