Am 31.01.2013 10:13, schrieb Kristján Valur Jónsson:
Ok, I've updated all three slp branches with their non-slp counterparts.
All should be fine, except I could have messed up the build scripts for
non-windows platforms. That has happened to me before.
These are typically autogenerated. Perhaps all there is needed is to re-run
the autogeneration step?
It would be great if someone could verify.
My automatic build setup runs fine with the latest 2.7-slp. It executes
autoreconf -v # recreate configure ...
./configure ......
because I add some additional patches to configure.ac (libedit instead
of libreadline). Therefore it seems to be sufficient to just run
"autoreconf" to rebuild configure.
Regards
Anselm
--
Dipl. Phys. Anselm Kruis science + computing ag
Senior Solution Architect Ingolstädter Str. 22
email [email protected] 80807 München, Germany
phone +49 89 356386 874 fax 737 www.science-computing.de
--
Vorstandsvorsitzender/Chairman of the board of management:
Gerd-Lothar Leonhart
Vorstand/Board of Management:
Dr. Bernd Finkbeiner, Michael Heinrichs,
Dr. Arno Steitz, Dr. Ingrid Zech
Vorsitzender des Aufsichtsrats/
Chairman of the Supervisory Board:
Philippe Miltin
Sitz/Registered Office: Tuebingen
Registergericht/Registration Court: Stuttgart
Registernummer/Commercial Register No.: HRB 382196
_______________________________________________
Stackless mailing list
[email protected]
http://www.stackless.com/mailman/listinfo/stackless
