I seem to remember work was once being done to make OPT interfaces work with PPPoE. Can someone tell me how to do this of if it can be done. I am using a Linksys box just for this purpose right now, but would like to get away from this.
-----Original Message----- From: Jonathan Wanak [mailto:[EMAIL PROTECTED] Sent: Wednesday, August 23, 2006 12:07 PM To: support@pfsense.com Subject: [pfSense Support] Configuring OPT1 as a second LAN Hi, Please forgive this question if it has already been addressed; I looked for the solution, but may have missed it. I'm configuring my pfSense router (RC2 hard drive installation on a Pentium II box with 3 NICs, 256MB RAM) with public and private LANs. I haven't been able to configure OPT1 to operate as a second LAN, and the interface configuration page looks more like the WAN configuration than the LAN configuration. I did succeed in doing this a long time ago with m0n0wall, but have forgotten the details involved. How do I configure OPT1 as a second (public) LAN interface, isolated from the primary (private) LAN interface? Are there firewall settings, filters, or other configuration steps I need to take to make this work? Any pointers would be greatly appreciated! Thanks, Jon Wanak --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
