Well, finally, there were two problems
I think I forget to mention I was using failover.
1) Time drift between both boxes
-------------IMPORTANT:-------------------------------------------------------
2) I've setup dhcp for two interfaces.One of them was working fine, the
other never could get synchronized.
Looking at the sockstat output on pf1 I saw that it had ports 519/tcp
open for both failover IPs.On pf2 it had port 520/tcp open for both IPs,
one ip from each interface with dhcp enabled and providing failover service.
The problem (and I think it's a nasty bug) is that connecting from
pf1->pf2'sFIRST_FAILOVER_IP:519 was working right, but connecting from
pf1->pf2'sSECOND_FAILOVER_IP:519 was not working.
The problem was solved by creating a rule which allows tcp ports 519-520
from and to failover ips.
Hope it helps in the future somebody else.
Thanks for your help.
Matias Surdi escribió:
Hi,
I'm using pfSense 1.2 , and suddenly DHCP seems to have stopped working.
On the system log, i see the following:
Oct 7 22:23:34 dhcpd: Internet Systems Consortium DHCP Server V3.0.5
Oct 7 22:23:34 dhcpd: Copyright 2004-2006 Internet Systems Consortium.
Oct 7 22:23:34 dhcpd: All rights reserved.
Oct 7 22:23:34 dhcpd: For info, please visit
http://www.isc.org/sw/dhcp/
Oct 7 22:23:34 dhcpd: failover peer declaration with no referring
pools.
Oct 7 22:23:34 dhcpd: In order to use failover, you MUST refer to
your main failover declaration
Oct 7 22:23:34 dhcpd: in each pool declaration. You MUST NOT use
range declarations outside
Oct 7 22:23:34 dhcpd: of pool declarations.
Any idea?
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
