OK Stan,
i forget to mention the principle of it.
once you remouved the Woodpole yuo should have a continuose line from your
Airintake to the Top you compressed Stock.
If some Sawdust fell down,while you pulled out the Pole,clean it out from the
Airchanel on the Bottom,so Air could flow all the way up to the Top of you
stock.Leaf some material loose on the Bottom of the Chanel and Ligth it there
(dont forget to close you cover before)
The Shavings and Sawdust will burn in the uprigth Cavity made by the Pole and
will gradually burn you stock from inside out!
Its very simple and create good Heat in a shop of your size!
Now DONT burn your Shop!!!
Good Luck
Fritz
Ps: Best for lighting are shavings of a handplane
----- Original Message -----
From: Stan Walker
To: biofuel@yahoogroups.com
Sent: Friday, February 06, 2004 6:02 PM
Subject: Re: [biofuel] WVO heater for shop
Fritz Hi Again
Your drumstove has given me an answer to my heating problems in my
factory. I find it a little bit difficult to fully understand the total
concept please if you would draw me something I am only an Aussie you must
understand Where do you light the heater and how? Thanks Stan
----- Original Message -----
From: "Friedrich Friesinger" <[EMAIL PROTECTED]>
To: <biofuel@yahoogroups.com>
Sent: Saturday, February 07, 2004 2:19 AM
Subject: Re: [biofuel] WVO heater for shop
> Hi Art,
> for the amount of Sawdust you need to burn in you Shop a 45Gal.Drumstove
would be sufficient!
> It works fairly simple you take the Drum,standing up,put a Airintake of
about 4" at the Bottom, cut a 6" Pipe in halve and create a Channel like
> Cover almost to the Center of your Barrel.
> The Smokepipe you fit below the Top of the Drum on the opposite Site and
Connect to your Chimminey.
> The Drum should be open completely to the Top.A Cover that fit good on
Top (1/4 Steelplate will doo) or a remouvable Cover of the Drum
>
> Now you fill your Drum with your Sawdust and Shavings but dont forget to
put a 4" Pipe or round Woodpole from Center beside your Channel up,sticking
out of the Drum.
>
> In filling up your Drum compact the Sawdust/Rip and fill your Drum
allways compacting your stock until reach of the Smokepipe.
> Pull out the 4"Pole ,cover your Lid and Light your new Sawdustheater,
> it works fine for a little Shop like yours!
> Keep the Area around your Stove clean,
> (4 Bricks under your Drum would not hurt,to keep the Stove away from the
Floor!
>
> Good Luck
> Fritz
> ----- Original Message -----
> From: Art Oswald
> To: biofuel@yahoogroups.com
> Sent: Friday, February 06, 2004 9:03 AM
> Subject: Re: [biofuel] WVO heater for shop
>
>
> Thanks for the info and picture. Your set up is way more than I
need.
> I have a small 20x20 shop.
>
>
> -----Original Message-----
> From: Friedrich Friesinger [mailto:[EMAIL PROTECTED]
> Sent: Wednesday, February 04, 2004 9:08 AM
> To: biofuel@yahoogroups.com
> Subject: [SPAM] Re: [biofuel] WVO heater for shop
>
> Hi Northlandwood,
> in my Woodshop i press all Sawdust and Shavings into Briquettes,they
are
> stonehard and only held by Pressure!
> The moistercontent of the Material shoult not exeed 15%
> The Press is mounted right under the Dustcollector and works
> automaticly,so i have no accumulation of explosive Sawdust
> if you need moore info dont hesitate to contact me
> Fritz
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
>
> Biofuel at Journey to Forever:
> http://journeytoforever.org/biofuel.html
>
> Biofuels list archives:
> http://archive.nnytech.net/index.php?list=biofuel
>
> Please do NOT send Unsubscribe messages to the list address.
> To unsubscribe, send an email to:
> [EMAIL PROTECTED]
>
>
>
> --------------------------------------------------------------------------
----
> Yahoo! Groups Links
>
> a.. To visit your group on the web, go to:
> http://groups.yahoo.com/group/biofuel/
>
> b.. To unsubscribe from this group, send an email to:
> [EMAIL PROTECTED]
>
> c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> Biofuel at Journey to Forever:
> http://journeytoforever.org/biofuel.html
>
> Biofuels list archives:
> http://archive.nnytech.net/index.php?list=biofuel
>
> Please do NOT send Unsubscribe messages to the list address.
> To unsubscribe, send an email to:
> [EMAIL PROTECTED]
> Yahoo! Groups Links
>
>
>
>
>
Biofuel at Journey to Forever:
http://journeytoforever.org/biofuel.html
Biofuels list archives:
http://archive.nnytech.net/index.php?list=biofuel
Please do NOT send Unsubscribe messages to the list address.
To unsubscribe, send an email to:
[EMAIL PROTECTED]
Yahoo! Groups Sponsor
ADVERTISEMENT
------------------------------------------------------------------------------
Yahoo! Groups Links
a.. To visit your group on the web, go to:
http://groups.yahoo.com/group/biofuel/
b.. To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]
------------------------ Yahoo! Groups Sponsor ---------------------~-->
Buy Ink Cartridges or Refill Kits for your HP, Epson, Canon or Lexmark
Printer at MyInks.com. Free s/h on orders $50 or more to the US & Canada.
http://www.c1tracking.com/l.asp?cid=5511
http://us.click.yahoo.com/mOAaAA/3exGAA/qnsNAA/FGYolB/TM
---------------------------------------------------------------------~->
Biofuel at Journey to Forever:
http://journeytoforever.org/biofuel.html
Biofuels list archives:
http://archive.nnytech.net/index.php?list=biofuel
Please do NOT send Unsubscribe messages to the list address.
To unsubscribe, send an email to:
[EMAIL PROTECTED]
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/biofuel/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
