On 2021/05/22 12:06, Mark Kettenis wrote:
> Can't find my raspberry pi3 right now. But here is a diff that avoids
> spinning with interrupts disabled while trying to grab the kernel lock
> for it. I'd appreciate it if somebody could give this a spin for me.
> Just checking whether it works normally for a bit would be fine.
Seems OK so far.
booting sd0a:/bsd: 8935756+1804632+570032+831592
[648870+109+1086336+636102]=0xf99638
type 0x0 pa 0x0 va 0x0 pages 0x1 attr 0x8
type 0x7 pa 0x1000 va 0x1000 pages 0x1ff attr 0x8
type 0x2 pa 0x200000 va 0x200000 pages 0x4000 attr 0x8
type 0x7 pa 0x4200000 va 0x4200000 pages 0x3cf5 attr 0x8
type 0x9 pa 0x7ef5000 va 0x7ef5000 pages 0x16 attr 0x8
type 0x7 pa 0x7f0b000 va 0x7f0b000 pages 0x3119d attr 0x8
type 0x2 pa 0x390a8000 va 0x390a8000 pages 0xd5b attr 0x8
type 0x4 pa 0x39e03000 va 0x39e03000 pages 0x1 attr 0x8
type 0x2 pa 0x39e04000 va 0x39e04000 pages 0x3 attr 0x8
type 0x7 pa 0x39e07000 va 0x39e07000 pages 0x1 attr 0x8
type 0x2 pa 0x39e08000 va 0x39e08000 pages 0x100 attr 0x8
type 0x1 pa 0x39f08000 va 0x39f08000 pages 0x2a attr 0x8
type 0x0 pa 0x39f32000 va 0x39f32000 pages 0x7 attr 0x8
type 0x4 pa 0x39f39000 va 0x39f39000 pages 0x1 attr 0x8
type 0x6 pa 0x39f3a000 va 0x5144e2a000 pages 0x1 attr 0x8000000000000008
type 0x4 pa 0x39f3b000 va 0x39f3b000 pages 0x2 attr 0x8
type 0x0 pa 0x39f3d000 va 0x39f3d000 pages 0x1 attr 0x8
type 0x6 pa 0x39f3e000 va 0x5144e2e000 pages 0x3 attr 0x8000000000000008
type 0x4 pa 0x39f41000 va 0x39f41000 pages 0x1 attr 0x8
type 0x6 pa 0x39f42000 va 0x5144e32000 pages 0x4 attr 0x8000000000000008
type 0x0 pa 0x39f46000 va 0x39f46000 pages 0x1 attr 0x8
type 0x4 pa 0x39f47000 va 0x39f47000 pages 0x1 attr 0x8
type 0x0 pa 0x39f48000 va 0x39f48000 pages 0x1 attr 0x8
type 0x4 pa 0x39f49000 va 0x39f49000 pages 0x2 attr 0x8
type 0x0 pa 0x39f4b000 va 0x39f4b000 pages 0x1 attr 0x8
type 0x4 pa 0x39f4c000 va 0x39f4c000 pages 0x2 attr 0x8
type 0x2 pa 0x39f4e000 va 0x39f4e000 pages 0x1402 attr 0x8
type 0x5 pa 0x3b350000 va 0x5146240000 pages 0x10 attr 0x8000000000000008
type 0x2 pa 0x3b360000 va 0x3b360000 pages 0xa0 attr 0x8
type 0xb pa 0x3f100000 va 0x5146250000 pages 0x1 attr 0x8000000000000000
[ using 2372384 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2021 OpenBSD. All rights reserved. https://www.OpenBSD.org
OpenBSD 6.9-current (GENERIC.MP) #3: Sat May 22 14:49:21 BST 2021
st...@mala.spacehopper.org:/sys/arch/arm64/compile/GENERIC.MP
real mem = 956895232 (912MB)
avail mem = 895025152 (853MB)
random: good seed from bootblocks
mainbus0 at root: Raspberry Pi 3 Model B Rev 1.2
cpu0 at mainbus0 mpidr 0: ARM Cortex-A53 r0p4
cpu0: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache
cpu0: 512KB 64b/line 16-way L2 cache
cpu0: CRC32,ASID16
cpu1 at mainbus0 mpidr 1: ARM Cortex-A53 r0p4
cpu1: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache
cpu1: 512KB 64b/line 16-way L2 cache
cpu1: CRC32,ASID16
cpu2 at mainbus0 mpidr 2: ARM Cortex-A53 r0p4
cpu2: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache
cpu2: 512KB 64b/line 16-way L2 cache
cpu2: CRC32,ASID16
cpu3 at mainbus0 mpidr 3: ARM Cortex-A53 r0p4
cpu3: 32KB 64b/line 2-way L1 VIPT I-cache, 32KB 64b/line 4-way L1 D-cache
cpu3: 512KB 64b/line 16-way L2 cache
cpu3: CRC32,ASID16
efi0 at mainbus0: UEFI 2.8
efi0: Das U-Boot rev 0x20210400
apm0 at mainbus0
simplefb0 at mainbus0: 656x416, 32bpp
wsdisplay0 at simplefb0 mux 1
wsdisplay0: screen 0-5 added (std, vt100 emulation)
"system" at mainbus0 not configured
"axi" at mainbus0 not configured
simplebus0 at mainbus0: "soc"
bcmclock0 at simplebus0
bcmmbox0 at simplebus0
bcmgpio0 at simplebus0
bcmaux0 at simplebus0
bcmdmac0 at simplebus0: DMA0 DMA2 DMA4 DMA5 DMA8 DMA9 DMA10
bcmintc0 at simplebus0
pluart0 at simplebus0: console
bcmsdhost0 at simplebus0: 250 MHz base clock
sdmmc0 at bcmsdhost0: 4-bit, sd high-speed, mmc high-speed, dma
dwctwo0 at simplebus0
bcmdog0 at simplebus0
bcmrng0 at simplebus0
bcmtemp0 at simplebus0
"local_intc" at simplebus0 not configured
sdhc0 at simplebus0
sdhc0: SDHC 3.0, 200 MHz base clock
sdmmc1 at sdhc0: 4-bit, sd high-speed, mmc high-speed
"firmware" at simplebus0 not configured
"power" at simplebus0 not configured
"mailbox" at simplebus0 not configured
"gpiomem" at simplebus0 not configured
"fb" at simplebus0 not configured
"vcsm" at simplebus0 not configured
"virtgpio" at simplebus0 not configured
"clocks" at mainbus0 not configured
"phy" at mainbus0 not configured
"arm-pmu" at mainbus0 not configured
agtimer0 at mainbus0: 19200 kHz
"leds" at mainbus0 not configured
"fixedregulator_3v3" at mainbus0 not configured
"fixedregulator_5v0" at mainbus0 not configured
"bootloader" at mainbus0 not configured
dt: 443 probes
usb0 at dwctwo0: USB revision 2.0
sdmmc0: can't enable card
uhub0 at usb0 configuration 1 interface 0 "Broadcom DWC2 root hub" rev
2.00/1.00 addr 1
uhub1 at uhub0 port 1 configuration 1 interface 0 "Standard Microsystems
product 0x9514" rev 2.00/2.00 addr 2
bwfm0 at sdmmc1 function 1
manufacturer 0x02d0, product 0xa9a6 at sdmmc1 function 2 not configured
smsc0 at uhub1 port 1 configuration 1 interface 0 "Standard Microsystems
SMSC9512/14" rev 2.00/2.00 addr 3
smsc0: address b8:27:eb:5d:c0:5e
ukphy0 at smsc0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI
0x0001f0, model 0x000c
umass0 at uhub1 port 2 configuration 1 interface 0 "SanDisk Ultra Fit" rev
2.10/1.00 addr 4
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <SanDisk, Ultra Fit, 1.00> removable
serial.0781558381079d26fa39
sd0: 29340MB, 512 bytes/sector, 60088320 sectors
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
root on sd0a (b2b4d0b998c15160.a) swap on sd0b dump on sd0b
WARNING: CHECK AND RESET THE DATE!
gpio0 at bcmgpio0: 54 pins
bwfm0: address b8:27:eb:08:95:0b
Automatic boot in progress: starting file system checks.
/dev/sd0a (b2b4d0b998c15160.a): file system is clean; not checking
/dev/sd0k (b2b4d0b998c15160.k): file system is clean; not checking
/dev/sd0d (b2b4d0b998c15160.d): file system is clean; not checking
/dev/sd0f (b2b4d0b998c15160.f): file system is clean; not checking
/dev/sd0g (b2b4d0b998c15160.g): file system is clean; not checking
/dev/sd0h (b2b4d0b998c15160.h): file system is clean; not checking
/dev/sd0j (b2b4d0b998c15160.j): file system is clean; not checking
/dev/sd0e (b2b4d0b998c15160.e): file system is clean; not checking
pf enabled
starting network
reordering libraries: done.
starting early daemons: syslogd ntpd.
starting RPC daemons:.
savecore: no core dump
checking quotas: done.
clearing /tmp
kern.securelevel: 0 -> -1
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sshd.
starting local daemons: cron.
Fri May 21 23:00:20 GMT 2021
