I suspect that 90% of the work could be done with a single kit. That will get
one card out of the chassis. But, there are always those annoying problems
where getting two cards out can make life a little easier. With two kits you
could also hack up the extra 44-pin board to make a smaller board (or boards)
for getting the odd-ball cards out (if you can find the required edge
connectors).
So far, I've only needed to do a single card...
I suspect most TM500 people will want two cables, but that depends upon what
modules you have. Most modules just have one connector. Some of the fancier
ones use two. And a very few use three. I even have a custom module that has
4... At first, I didn't think that the TM5000 GPIB extender cable would be
all that important, but I have wound up using it several times.
------------------
Hi Mark - do you recommend one 5370 Extender set or two?
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
