Hi Andrea, On Thursday 07 February 2008, R&D4 wrote: > we are currently using u-boot (1.2.0) on our ARM9 based platform to boot > WinCE 4.2, 5.0 and 6.0 images (.bin). > More than this we also changes some part of WinCE BSP to allow passing > "kernel bootline parameters" (as much like in linux ;-) ) to configure > console output (on serial line) or ip configuration.
Thanks. That's good news. > If you want I can send you the patch: it's a bit "ugly" ;-) but it can > be made platform indipendent with ease. > Basically it adds a new command (bootwince) which is much like bootm, > but "check AND decompress" .bin images and run WinCE. > Of course the WinCE image can be started directly RAM (e.g. downloaded > via TFTP for debugging pourpose) or from Flash (for stand alone > operations). Yes, please send me the patch. Perhaps we will clean it up and integrate it into the common source. Thanks. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
