I want to use nt5x-install to accept filename 8.3.3
I want to use the new network e1000 driver (Dell Optiplex 755)
So, I compiled the official unattended-4.7 version. (not CVS)
I had a lot of problems with samba and finaly, I used samba-3.0.20
As you said me, the procedure was:
- Patch unattended with altdosemu-2008-03-17.tar.gz
and the 3 patchs altdosemu-xxx.patch
- I modified Makefile to use samba-3.0.20
make download
- Modification of linux-xxx/driver/net/e1000
make tftpboot.
The compiling was OK and I started an PXE installation.
network is OK
mounting Z /ntinstall/install OK
----- /usr/bin/nt5x-install -----
start, but immediatly stop with this messages:
program parted is using deprecated SCSI ioctl ......
* Saving existing disk geometry into /dev/dsk1
* Writing ntlbr-boot-code-sector0 into /dev/dsk1
* Writing ntlbr-boot-code-sector12 into /dev/dsk1
* Writing saved disk geometry back into /dev/dsk1
could not write C/netinst/partgeo.bin into /dev/dsk1
dropping to shell ....
The versions used are:
build-glibc-2.3.6 linux-2.6.23.11 glibc-2.3.6 parted-1.6.22
Do you know this problem ?
Régis
--
==================================================================
| Régis Gras | http://dcm.ujf-grenoble.fr |
| D.C.M. | mailto:[EMAIL PROTECTED] |
| 301, rue de la chimie | -------------- |
| DU BP 53 | Tel 04 76 51 41 76 |
| 38041 Grenoble Cedex 9 | Fax 04 76 51 40 89 |
==================================================================
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
unattended-info mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/unattended-info
