One thing I forgot to mention. Having edited the corrections list, be sure to apply it in the document by clicking Apply Corrections in the Tools menu. You'll get the option only when a file is open. ----- Original Message ----- From: "Viraj" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, February 17, 2008 11:03 AM Subject: Re: [AI] strange problem with k1000.
>I have faced such problems even in earlier versions and have been unable to >come up with definite solutions. However, one can try the following: > > 1. Switch to Fine reader engine if one is using RTK or Scansoft. > 2. Try switching to Grey Scanning mode. > 3. Click Edit Corrections in the Tools menu, press Add, enter the word as > it is being recognised, such as, odier, and press OK. Now enter the > correct word, (other in this instance). Edit all other words that often > gets misrecognised in the same way. But sometimes this can result in the > replacement of actually correct words with wrong words. For instance, if > the program learns to recognise all di as th, then actual words with di > will also be converted into th (like the word die will be converted into > the). However, what one can do (though it does not guarantee 100 per cent > success) is to enter the entire word in the edit corrections list, instead > of letter combination, for instance, odier and other instead of di and th. > 4. One can also try the Replace All command (control H). But here also one > should be careful to replace the entire wrong word instead of letter > combinations, else one will get wrong results. one can try enabling the > Match Whole Word option in the Rplace dialogue box. > > One can never hope that issues wil be resolved for good through these > steps, but one can always try. > > Please note that the menu commands described above are based on > version 9. Look around if version 11 has different menu arangements. > ----- Original Message ----- > From: "Mahesh Panicker" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Saturday, February 16, 2008 9:48 PM > Subject: [AI] strange problem with k1000. > > >> Hi list. >> I am facing a strange problem with Kurzweil1000 version 11. when I scan a >> document, the letter combination TH gets recognized as DI. for EG, the >> word >> that gets recognized as diat. >> what can be the sorce of this particular problem? how can it be >> addressed? >> looking forward to your suggestions. >> thanks in advance. >> >> >> -- >> Mahesh S. Panicker >> room no. 121; >> Kaveri-hostel; >> Jawaharlal Nehru university new delhi 110067 india. >> To unsubscribe send a message to [EMAIL PROTECTED] >> with the subject unsubscribe. >> >> To change your subscription to digest mode or make any other changes, >> please visit the list home page at >> >> http://accessindia.org.in/mailman/listinfo/accessindia_accessindia.org.in > To unsubscribe send a message to [EMAIL PROTECTED] with the subject unsubscribe. To change your subscription to digest mode or make any other changes, please visit the list home page at http://accessindia.org.in/mailman/listinfo/accessindia_accessindia.org.in
