Friends I am facing strange problem in kurzweil 1000 v 13. There are 2 recognition engens in recognition tab under setting menue in kurzweil. Usually we use fine reader recognition engen, as it is set by default which recognise the page when we scan any document. If I am scanning any page, after scanning, when kurzweil starts to recognise the page, an error appears in a dialogue box and that is : "run time error". If I press OK butten, kurzweil closes down and I have to restart kurzweil again. How ever before scanning if I am changing recognition engen from fine reader engen to scan soft engen 18.0, it recognises the page as usual. But the recognition results are not good with scan soft engen . Please guide me how to resolve this issue. I have done too much trouble shooting, I have uninstalled and reinstalled kurzweil many times after removing it completely, I have removed fine reader and reinstalled it just in case if it was the culpret. Interestingly Kurzweil 12 is working fine with fine reader recognition engen
-- Mohib Anwar Rafel 2009 - 2011 M.Phil, International Legal Studies, JNU. 2011 - 2013 LL.M, Faculty of Law, University of Delhi. 2013 - Pursuing Ph.D in International Law, JNU Skype: mohibrafel Phone: 09811767506, 09211192333 Register at the dedicated AccessIndia list for discussing accessibility of mobile phones / Tabs on: http://mail.accessindia.org.in/mailman/listinfo/mobile.accessindia_accessindia.org.in Search for old postings at: http://www.mail-archive.com/[email protected]/ To unsubscribe send a message to [email protected] with the subject unsubscribe. To change your subscription to digest mode or make any other changes, please visit the list home page at http://accessindia.org.in/mailman/listinfo/accessindia_accessindia.org.in Disclaimer: 1. Contents of the mails, factual, or otherwise, reflect the thinking of the person sending the mail and AI in no way relates itself to its veracity; 2. AI cannot be held liable for any commission/omission based on the mails sent through this mailing list..
