RE: [ActiveDir] Forest Prep and ADC

[Taylor, Eric]

You should be able to run the /schemaonly switch prior to performing OrgPrep. -----Original Message----- From: Rittenhouse, Cindy [mailto:[EMAIL PROTECTED]] Sent: Wednesday, June 05, 2002 10:33 AM To: '[EMAIL PROTECTED]' Subject: RE: [ActiveDir] Forest Prep and ADC Thanks, I can get it from TechNet, I was using the Guide to Upgrading from MS Exchange Server 5.5 to Exchange 2000 Server, and it left me unclear as to where the ADC was to be installed? I don't plan to upgrade Exchange for some time, but I wanted to extend the AD schema from the start, to avoid extensive replication time later. -----Original Message----- From: Lori Demkovich [mailto:[EMAIL PROTECTED]] Sent: Wednesday, June 05, 2002 10:20 To: [EMAIL PROTECTED] Subject: RE: [ActiveDir] Forest Prep and ADC Cindy, what you need is the Exchange 2000 Internals Installation and Setup Guide, which I"ll send to you in a separate email if you wish. (But I think it is also on the Technet CD)  Its an excellent doc.  Essentially, you'll do the following:   1. Install the ADC 2. Run /Forestprep 3. Run /domainprep 4. Create required connection agreements 5. Go home and rest while replication is going on...  6. Run Exchange 2000 setup.   When using the guide, use the section dedicated to Integrating with Exchange Server 5.5.   Good luck and have fun!   LCD         -----Original Message----- From: Rittenhouse, Cindy [mailto:[EMAIL PROTECTED]] Sent: Wed 6/5/2002 10:10 AM To: [EMAIL PROTECTED] Cc: Subject: [ActiveDir] Forest Prep and ADC I am working in my test lab and I am unclear about the requirements for ForestPrep. I have an AD root domain and an NT domain. My AD root consists on 2 DCs only. DNS, DHCP, and WINS are in place. There is a trust between the domains.  I have read that it is best to run ForestPrep at this point, but my Exchange 5.5 server (a W2K member server) is in the NT domain. I have documentation that says ADC must be installed in the Forest before I can run ForestPrep. Since the Exchange server is not located in the Forest/AD domain, do I need to install the ADC on one of these DCs. Will it allow me to join an existing Exchange 5.5 Organization in an NT domain. Do I need the ADC installed on the Exchange server before I Forest Prep the AD root domain. Thanks Cynthia Rittenhouse, MCSE, CCNA LAN Administrator County of Lancaster 900 E. King St. Lancaster, PA 17602 Phone: (717)293-7274