Did you use the original OPT file? If so, there are some options that can cause Dr
Watson errors. They are options that are no longer supported by the newer client, we
have experienced this issue also and found this cause.
-----Original Message-----
From: Gottfried Scheckenbach
[mailto:[EMAIL PROTECTED]]
Sent: Thursday, April 12, 2001 11:24 AM
To: [EMAIL PROTECTED]
Subject: Re: Dr. Watson in NT after installing TSM4.1
Because there where no answers:
Today I had the same problem - after upgrading a old ADSM 3.1 to TSM 4.1
installation on NT with SP 3. Just after installation of SP 6 all went fine.
Regards,
Gottfried
Shekhar Dhotre wrote:
>
> Hi all ,
>
> I installed TSM server 4.1 on WINNT 4.0 service pack 4 , RAM 256 MB
> whenever i open configuration wizard to configure any of the parameters in
> TSM
> DR. WATSON shows his face .. what should i check to correct this problem ..
>
> Thanks
> shekhar
