I forgot that the ATA can't auto answer, it would need some way of
putting the line on/off hook external to the ATA. A VoIP Phone with
audio input jack might be the best way.
On 11/7/2018 1:27 PM, Chuck McCown wrote:
The easiest way would to buy an old phone from a thrift store if you
can, unscrew the caps off of the handset and use the transmitter and
receiver wires to interface the audio.
Sent from my iPhone
On Nov 7, 2018, at 9:40 AM, Nate Burke <[email protected]
<mailto:[email protected]>> wrote:
Unfortunately no cat5 to the soundboard, the aforementioned wall
problem, so I'm limited to WIFI. I should be able to put a phone on
the end of a WIFI Adapter though. Can you somehow wire an Analog
Telephone plug so that it would accept an RCA Jack input? Then I
could just use an ATA. I found this
https://www.amazon.com/JK-Audio-THAT-1-Telephone-Handset/dp/B003D82WHK but
it looks pretty expensive for what I suspect are a few cents worth of
components.
On 11/7/2018 10:31 AM, [email protected] wrote:
If you are not extremely interested in low latency or high quality.
*From:* [email protected]
*Sent:* Wednesday, November 7, 2018 9:23 AM
*To:* AnimalFarm Microwave Users Group
*Subject:* Re: [AFMUG] OT: Wireless Sound System monitor speaker
I would use SIP with auto-answer. Connect a phone to the sound board
and depending on the phone,
either custom wire the handset jack or if it has a 3.5mm jack you
could use that. Set the phone to
auto answer and you could dial in from anywhere.
On Wed, Nov 7, 2018 at 11:18 AM Nate Burke <[email protected]> wrote:
I'm trying to get a monitor speaker off a mixing board to a
different
part of a building. 100+ year old construction, a 20" thick
brick wall
between the mixing board and the endpoint, and a cable run of
probably
400-500' involving a lot of fishing of wires. I'm trying to come
up with
a way to avoid running wires if I can. Straight line distance
between
the 2 points is about 150' WIFI is available at the sound
board, and a
hardline cat5 at the remote end, but I need something idiot
proof that
just turns on and works. One thought was maybe a SIP Setup
(there is
already a SIP Pbx in place), some sort of ATA that would
connected to
the monitor out of the board then could be dialed from another SIP
Extension? Not sure if such a beast exists.
I'd also be open to a simple wireless speaker, but would have to
be low
enough frequency to operate at distance through a couple walls, so
Bluetooth is probably out. Audio quality is a secondary
concern, it's
more of a "What's happening right now in the other room" need.
Any of
you Pro Audio guys have any suggestions?
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
------------------------------------------------------------------------
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
