You can kick them back to timing over power using telnet.
Just telnet to the AP, and issue "synconboard off" wait a second and
then issue "synconboard on"
It's best to first make sure it sees the other source on the "Home >
Sync Status" tab.
Good luck,
Matt Mays
Amplex Internet
On 2/28/2019 9:25 AM, Eric Muehleisen wrote:
I have 8 Canopy 450 AP's all receiving sync and power from a
RackInjector. Last night 3 of the 8 AP's lost sync and rolled over to
On-Board GPS. Only a hand-full of SM's re-registered on 2 of the AP's.
Sync loss happened on 2 different cards, not the same card. Looking in
the RackInjector logs, there was nothing to indicate a problem. I'll
assume it's an issue with the 450 AP's. We run a blend of different
software ranging from 15.1.5 and 15.2.
My question is, the sync source change, if long enough, may cause a
re-reg. We do back-to-back freq. reuse on 2 AP's. Do you think the
different sync sources could cause an issue or drift over time? I'm
not sure if the affected AP's will roll back over to the sync/power
source. A reboot may be required. As of now, there doesn't seem to be
any self-interference.
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
