They make single hole conduit hangers. https://bit.ly/3nCm5Up
Unistrut stud nut: https://bit.ly/3pHd920
Add 1/4-20 hex nuts and washers.
On 11/19/2020 1:40 AM, Steve Jones wrote:
You'd think this would exist. You could probably just twist the tits
on a standard clamp and go one size larger, but that probably would
cause a stress failure
On Thu, Nov 19, 2020, 12:18 AM Jason McKemie
<[email protected]
<mailto:[email protected]>> wrote:
Does anyone know if there is any sort of bracket available that
will allow me to run a pipe at an adjustable angle in relation to
a piece of unistrut? They have clamps that will do 90 degrees or
run parallel to the unistrut, but nothing in between as far as I
can tell. I really need something that will do an arbitrary angle.
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
<http://af.afmug.com/mailman/listinfo/af_af.afmug.com>
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
