How much load? meanwell drs-480-48 are pretty good, if you need bigger than 10a/480w you can parallel or go to ICT or used eltek j series on ebay, which can be programmed for the correct voltage..
On Fri, Apr 5, 2024 at 1:13 PM Robert <i...@avantwireless.com> wrote: > LifePowers have a BMS. But most people power them with a LFP designed > charger to get the power into them much faster than a regular power supply. > > On 4/5/24 12:13 PM, Chuck McCown via AF wrote: > > You will need a BMS unless the battery has one built in. If it does, > > a regular telco rectifier will do the job. > > > > -----Original Message----- From: Mark - Myakka Technologies via AF > > Sent: Friday, April 5, 2024 10:58 AM > > To: af@af.afmug.com > > Cc: Mark - Myakka Technologies > > Subject: [AFMUG] LiFePO4 question again > > > > I'm finding hard to pass up just getting a 100ah 48v LiFePO4 rackmount > > battery. I have a new fiber system that will need a maximum of 3kw > > once it is maxed out over the years. This seems like an easy and > > clean battery solution. > > > > Question is how do I power the system from the AC side on a daily > > basis and keep the battery charged. The normal rectifier way seems to > > be a bit lacking in LiFePO4 support. > > > > I can get a EG4 Chargeverter 48V 100A Battery Charger that looks like > > it would do the job. Not sure if this thing is designed to run 24/7 > > at load or if it is designed for intermittent loads to just charge > > batteries. > > > > Thoughts? > > > > -- > > > > Thanks, > > Mark mailto:m...@mailmt.com > > > > Myakka Communications > > www.Myakka.com > > > > > > > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- Thank you, TJ Trout Volt Broadband 209.480.3122 Cell
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
