It took me a half hour to get them to run the first airview, a second one would be out of the question, theyre....tempermental
On Thu, Feb 12, 2015 at 1:36 PM, Caleb Knauer <[email protected]> wrote: > After you turned of the vzw hotspot did you run another airview? > > Maybe it's picking up 5Ghz noise from the hotspot? 3.65 is > downconverted 5Ghz. But I'd imagine that it would be highly unlikely > to cause that much of an issue. > > On Thu, Feb 12, 2015 at 2:30 PM, That One Guy <[email protected]> > wrote: > > Have techs at a customer house right now, its a 9 mile shot on 5mhz > > nanostation, but best we ever see on a speedtest was 3x1 ish at Signal > > Strength: > > > > -68 dBm > > Horizontal / Vertical:-72 / -69 dBm > > Noise Floor:-95 dBm > > Transmit CCQ:87.2 % > > TX/RX Rate:26 Mbps / 29.25 Mbps > > so we ran a spectrum in airview and there is a peak power from > 3550-3725mhz > > at -75 alot like what you see with an fhss system > > its air view so i take it with a grain of salt. > > > > he has a verizon hotspot and we shut it off speedtests went consistently > to > > 8x4 whic on a populated access point at that channel size with ubnt is > about > > what I was expecting. > > > > I did not think there was anything that could use that set of spectrum at > > once, does verizon have some sort of license in that band? > > > > The guys are still troubleshooting so it could be a coincidental thing > that > > it started working > > > > > > > > -- > > All parts should go together without forcing. You must remember that the > > parts you are reassembling were disassembled by you. Therefore, if you > can't > > get them together again, there must be a reason. By all means, do not > use a > > hammer. -- IBM maintenance manual, 1925 > -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
