Strange SFP issues in general or just with the SFP+ port? I'm told that the nexus switch at the other end is operating correctly, so I'm going to have to change routers at this end.
On Friday, February 20, 2015, Erich Kaiser <[email protected]> wrote: > If I recall this was the model that others were complaining about having > strange issues. You may want to go up to the CCR1036-8G-2S+ I know this > works with 1Gbps and 10Gbps. Also if you are using POE to power it, you > can do the same with the 1036 just open the cover and wire your DC into the > 2nd power terminal on the board. Take note the 1036 router draws about 60w. > > Erich Kaiser > North Central Tower Consulting > [email protected] > <javascript:_e(%7B%7D,'cvml','[email protected]');> > Office: 630-621-4804 > Cell: 630-777-9291 > > On Fri, Feb 20, 2015 at 2:41 AM, Jason McKemie < > [email protected] > <javascript:_e(%7B%7D,'cvml','[email protected]');>> wrote: > >> Thanks. The model is CCR1009-8G-1S-1S+. I'm getting some additional >> strange behavior. If I disable auto negotiation, the link light comes on >> using the SFP+ port. However, the other end (a Cisco Nexus switch) still >> shows the interface as down. The standard sfp port claims to get a link >> with auto negotiation active, but shows "failed" in the auto negotiation >> field. Any way it is configured, this also shows down on the Cisco. I'm >> using generic optics right now, but we've gotten the same result using >> Cisco optics at both ends. I'll have to try changing the rate select and >> rebooting next. >> >> On Thursday, February 19, 2015, Erich Kaiser <[email protected] >> <javascript:_e(%7B%7D,'cvml','[email protected]');>> wrote: >> >>> [image: Inline image 1] >>> >>> Try setting it to low and reboot also can try setting speed/duplex >>> 1000FDX I have heard what George is talking about as well, what model is it >>> that you are using? >>> >>> Erich Kaiser >>> North Central Tower Consulting >>> [email protected] >>> Office: 630-621-4804 >>> Cell: 630-777-9291 >>> >>> On Thu, Feb 19, 2015 at 5:36 PM, Jason McKemie < >>> [email protected]> wrote: >>> >>>> So disable auto negotiation or just set it to only advertise 1000M >>>> full? I only see 10Gbps as being an option when auto negotiation is >>>> disabled. >>>> >>>> On Thursday, February 19, 2015, Erich Kaiser < >>>> [email protected]> wrote: >>>> >>>>> Change speed setting inside interface and reboot the router. >>>>> >>>>> Erich Kaiser >>>>> North Central Tower Consulting >>>>> [email protected] >>>>> Office: 630-621-4804 >>>>> Cell: 630-777-9291 >>>>> >>>>> On Thu, Feb 19, 2015 at 5:04 PM, Jason McKemie < >>>>> [email protected]> wrote: >>>>> >>>>>> Can anyone think of any reason the same SFP/fiber will link up when >>>>>> plugged into a SFP port on a CCR, but will never establish a link when >>>>>> plugged into a SFP+ port? >>>>> >>>>> >>>>> >>> >
