Thx. I wont have a chance to test agaie till Friday. Jaime Solorza On Mar 2, 2015 11:41 AM, "D. Ryan Spott" <[email protected]> wrote:
> Hope this helps you Jaime, it is just some notes from a PTP and a PTMP > setup I have that seem to be delivering good results. > > When I was running in a noisier environment (PTMP with 12 CPE) I went with > an 8mhz channel width to give decent throughput but not wide enough to be > affected by all of the noise. > > ryan > > On 3/1/15 12:57 PM, Jaime Solorza wrote: > > Will try that > > Jaime Solorza > On Mar 1, 2015 1:03 PM, "John Woodfield" <[email protected]> wrote: > >> I've been having far better success using Mikrotik 9hpn radios. YMMV in >> that regard. >> >> >> >> I'm guessing you weren't passing data because you need to enable WDS on >> the AP and station. >> >> >> >> >> >> >> >> John Woodfield, President >> >> Delmarva WiFi Inc. >> >> 410-870-WiFi >> >> >> >> -----Original Message----- >> From: "Jaime Solorza" <[email protected]> >> Sent: Sunday, March 1, 2015 11:54am >> To: "Animal Farm" <[email protected]> >> Subject: [AFMUG] Rocket M900 tests >> >> Hello Kool Kats: >> Hope you are enjoying a nice Sunday. Well I know some of you are in the >> clutches of ole man Winter. >> Did some testing with the M900 Rocket with dual pol Yagi installed at >> Condor's Lower Comanche Peak site Friday afternoon. >> The Good: Even at 8 miles blocked by buildings and houses, I could see >> the AP on site survey menu with signals in the -89 to -95 dBm range but no >> association. We had a mast with two antennas and M900 on truck with >> height about 10 ft. AGL. We moved to higher point and signal jumped to >> -75 dBm, >> The Bad: Radios associated but would not pass traffic using 5MHz >> channels. I tried 3 MHz channels as well and would not either. Noise >> floor was jumping from -95dBm to -81 dBm.. >> The association would stay up at -79 dB while moving and drop. As soon >> as we had clear shot with would connect but pass no traffic from Internet. >> I could make changes to AP but that was all. >> We moved closer to site and parked at furniture store with clear LOS. >> Even with a -65 dBm at 6 miles ,,,no Internet traffic. I had an IP from MT >> and speed test would load slowly and error out with latency message. >> Pings were all over the place with a few time outs. So interference was >> too great in this part of town to use these. I will share screen shots in >> later posts. >> We knew the 902.928 MHz noise floor in central and east side of El Paso >> was high so I was not surprised. On the far west El Paso which borders >> with New Mexico, we have a water company using these for SCADA and cameras >> at 1 1/2, 3 and 6 miles with no problems using 5 MHz channels colocated >> with Phoenix Contact FHSS 900MHz I/O. This link has an Ubiquiti sector >> on AP and dual TY-900 antennas at CPE side. >> Note: The M900 AP is collocated with several M5 rockets on same tower. >> Jaime Solorza >> Wireless Systems Architect >> 915-861-1390 >> > > -- > D. Ryan Spott | Iron Goat Networks, llc > broadband | telco | colo | community > PO Box 1232 / 603 W. Stevens Sultan, WA 98284360-799-0552 | gtalk: > [email protected] > >
