We seal ours as well. I recrimped most of the premade cables I purchased after I got a batch where the ends just came off. Assemble the equipment on the ground for testing, go to line the antenna up for a test shot, notice no signal, the coax is laying on the ground.
I didn't take the end off, just hit it again with the crimpers from each direction. That has made me a bit gun shy about LMR400, especially after it happened on a tower. ----- Original Message ----- From: Josh Luthman To: [email protected] Sent: Tuesday, April 07, 2015 12:49 PM Subject: Re: [AFMUG] Quick antenna question Nearly all of my coax is preterminated. It's all a) Streakwave or b) included with the antenna. I can't recall if we've ever had a problem with any of it, but we always use coax seal. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Apr 7, 2015 at 1:34 PM, Glen Waldrop <[email protected]> wrote: 15dBi omni and ~15 to 20ft LMR400. Lightning blew the door off the power box on the ground, fried the mini PCI cards, but the RB600 still worked, just no data across the ethernet port. The unit was hit in 09, was replaced and the antenna and coax have been in service the whole time. I never replaced it as I thought the hinky rx signal was just misreported, a 24Mbps link @ -88 shouldn't happen. Rx signal quality has finally gone down to match the actual numbers now, so I think something in the antenna was damaged. The problem I have here is quality cables. I've gone through around 50 that were replaced by Streakwave. They had a bad batch. Made me quite shy to replace what appears to be a good cable with one that might just quit like some others have. I made this one in late 08. ----- Original Message ----- From: Jaime Solorza To: Animal Farm Sent: Tuesday, April 07, 2015 12:12 PM Subject: Re: [AFMUG] Quick antenna question more info ...what kind of antenna? how much RF cable and what kind is it? what do connectors look like ? Jaime Solorza Wireless Systems Architect 915-861-1390 On Tue, Apr 7, 2015 at 11:09 AM, Glen Waldrop <[email protected]> wrote: I had a tower hit by lightning. The antenna appeared to survive, so I replaced electronics and let it go. The system reports low rx signal, 20dB worse than expected, but got the speeds I expected, so originally I thought the signal was just being misreported by the new equipment. It has degraded now, so we're working on it this afternoon. I'm replacing the antenna, but what are the odds that the coax is damaged as well? I've got spare, probably going to send it up with the climber anyway.
