Sounds like a problem I reported as follows:
* ePMP 1000 - Unable to change configuration on SM after upgrading from 2.2 to 2.3.1 - Once a device has been upgraded it continues to operate, however, no further configuration changes can be saved. - A truck roll to swap the unit or pin reset/re-config is required. Steve _____ From: Af [mailto:[email protected]] On Behalf Of Josh Luthman Sent: Tuesday, April 21, 2015 1:42 PM To: [email protected] Subject: Re: [AFMUG] ePMP Red Triangle ! On that note there was a bug in 2.3.4 (may still be around, not sure) that would let you select a higher tx power than you could get away with. It would save and look all happy. However, if you look at the status tab it would be 0tx because you were trying excessive EIRP. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Apr 21, 2015 at 1:12 PM, [email protected] <[email protected]> wrote: Take a look at the Notifications tab and it should tell you what the problem is. A lot of times it may be that you have the power set to high for the frequency or antenna. On Tue, Apr 21, 2015 at 12:58 PM, Jerry Head <[email protected]> wrote: Usually when you get the red triangle there is a setting somewhere that the radio does not like. Take a look at the network page again and look for errors. On 4/21/2015 10:33 AM, SmarterBroadband wrote: Rebooted a couple of times. From: Af [mailto:[email protected]] On Behalf Of Josh Luthman Sent: Tuesday, April 21, 2015 8:14 AM To: [email protected] Subject: Re: [AFMUG] ePMP Red Triangle ! Did you do a firmware upgrade and forget to reboot? Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Apr 21, 2015 at 11:07 AM, SmarterBroadband <[email protected]> wrote: On a ePMP running 2.4 software set as an AP (One customer CPE connected) both radios installed yesterday. On the AP we have a red triangle with an exclamation mark in it on the Network tab in configuration. The radio will not let us save changes now, save button grayed out. Radio is operational and passing traffic. Just want to set MIR profile in AP.. Any ideas what can cause this? Hoping not to have to go to site and reset to factory defaults. Thanks Adam
