I have a lab/bench setup. Every one gets tested to a known good AP. The
P9 boards can vary quite a bit. The most common issue I see with field
returned radios is damaged pigtails and/or the RF section just took a
shit. Off in the round filing cabinet they go, not even worth getting
them fixed anymore. Yes, P10's are far more stable and consistent.
Calibration issues are rare anymore. The only time I really see bad cal
data is when a board takes a nearby lightning strike and the flash is
corrupt, but for some reason they still boot, just default calibration
values. Still not worth trying to get those fixed. I throw them in a
pile for later.
I've always seen P9 APs underperform. The RF output isn't as stable.
This isn't that bad at 900 and 2.4, but totally sucks on 5GHz. Every one
of the P9 5.7's we had up had to be swapped with P10's or 11's. Went
through three APs at one site and finally put in a P10 and all of the SM
power levels came up 8-10dB. Drove me nuts for a month.
On 6/30/2015 8:18 PM, Brandon Yuchasz wrote:
Ok so to answer Steve�s question. No filter on this I have never seen
one of the filters but have heard of them.
I should point out that this AP is deployed now. The test as a SM was
done a few weeks ago along with a bunch of other equipment most SMs
came in around -72 a few came in around -80. We tested a couple APs
and they both were -80ish. We assumed at the time that it was normal.
Now I am doubting that assumption. This deployed AP is having some
issues with far out SMs in the 8 and 9 mile range. The AP it replaced
was not having these issues although this one is higher in elevation
than the last one so not everything is identical.
At this point a climb is planned for the AM to put in a p10 AP.
Best regards,
Brandon Yuchasz
GogebicRange.net
www.gogebicrange.net <http://www.gogebicrange.net/>
*From:*Af [mailto:[email protected]] *On Behalf Of *[email protected]
*Sent:* Tuesday, June 30, 2015 7:50 PM
*To:* [email protected]
*Subject:* Re: [AFMUG] FSK 900mhz AP to SM should it read the same as
a SM?
From what I understand FSK Canopy doesn't estimate incoming signal
level, more that it adjusts the rx pre-amp until it sees a signal it
likes and then based on rx pre-amp setting it guesses what the
incoming signal was. So 2 different Canopy units can in the exact same
situation and signal can show a difference up to about 10db.
The calibration setting affects what signal level the SM shows but
don't play with that as you can fry the radio as Paul found out.
------------------------------------------------------------------------
*From: *"Brandon Yuchasz" <[email protected]
<mailto:[email protected]>>
*Sender: *"Af" <[email protected] <mailto:[email protected]>>
*Date: *Tue, 30 Jun 2015 17:04:43 +0000
*To: *<[email protected] <mailto:[email protected]>>
*ReplyTo: *[email protected] <mailto:[email protected]>
*Subject: *[AFMUG] FSK 900mhz AP to SM should it read the same as a SM?
So I am trying to trouble shoot some APs. FSK 900mhz.
I have a P9 AP when I set it to run as an SM it reads a -80 but when I
put an actual SM in its place it reads -72. Should there be a
difference between these two units or do I just have a crap AP?
Best regards,
Brandon Yuchasz
GogebicRange.net
www.gogebicrange.net <http://www.gogebicrange.net/>
