Washers could stop the horizontal strut from hitting the side of the
tank, but the two vertical struts will be rotated away from each other.
Are there fittings to connect them at an angle to each other rather than
perpendicular?
On 9/24/2015 9:39 PM, Mark Radabaugh wrote:
Huh - that’s awesome.
I have a tank like that I have been trying to figure out a better mount for.
Never thought of using unistrut vertical on the rails.
Look in the unistrut catalog and you should find enough parts to build
something close.
I’m thinking two struts vertical with beam clamps to clamp them to the
horizontal banding, and then horizontal strut across with spacers (square
washers) to compensate for the radius. Pipe clamps to hold the round pipe
vertical.
Mark
On Sep 24, 2015, at 9:22 PM, Adam Moffett <[email protected]> wrote:
I need to attach to a water tank identical to the one in the Sprint
installation in the attachments.
I noticed the drawing doesn't match the as-built photo. In the drawing they're
calling for galvanized angle bent around the curvature of the tank. In the
photo it's flat plates. Gee, I wonder which one bent easier.
Does anyone sell ready made hardware for this, or is it going to be custom fab
stuff?
<antenna 5.pdf><Attenna mounting detail Glass Lined Tanks.pdf>
