They connect and pass data @ -90!!! Just finished reconfiguring a SCADA network and needed to make a change on another radio. On a hunch i changed SSID and connected. Saved me a trip to that well site. These are all Bullet M5s
Jaime Solorza On Oct 7, 2015 2:11 PM, "Jeremy" <[email protected]> wrote: > I would not expect -86 and -89 to stay connected, on any firmware. > > On Wed, Oct 7, 2015 at 2:01 PM, Justin Marshall <[email protected]> > wrote: > >> Sorry, >> >> >> >> That should have read: >> >> This AP originally had 6 SM’s connected at *5690* >> >> >> >> *From:* Af [mailto:[email protected]] *On Behalf Of *Justin Marshall >> *Sent:* Wednesday, October 07, 2015 3:57 PM >> *To:* [email protected] >> *Subject:* [AFMUG] Client can't connect since UBNT 5.6.2 Firmware upgrade >> >> >> >> Hi, >> >> >> >> >> >> I recently updated a UBNT Rocket M5 to 5.6.2 from 5.5.4. Since this >> update, one of the clients will not connect. >> >> >> >> This AP originally had 6 SM’s connected at 5490. After the upgrade from >> 5.5.4 to 5.6.2, 2 of the SM’s didn’t come back. These 2 were not at the >> best signal (-86 and -89). If I swapped frequencies to 5740 the 1 >> connected at -86 popped back up at an -88 and the other SM’s are ~-2 db. >> But still no sign of the one that was at -89. >> >> >> >> This led me to believe UBNT probably lowered the output power for DFS >> frequencies somewhere between 5.5.4 and 5.6.2… >> >> >> >> One would think that downgrading the SM’s and AP back down to 5.5.4 would >> put things back the way they were but that doesn’t seem to be the case. >> >> >> >> I even sent a tech onsite to swap out the unreachable SM with one that >> had 5.5.4 on it. He said the one with 5.5.4 and the one with 5.6.2 both >> see the AP at -89 under “Site survey” but won’t register to the AP. >> >> >> >> I’m at a loss here… Does anyone have any suggestions of things to try, or >> a magic firmware version (folks on the UBNT forums say 5.5.4 is best for >> DFS frequencies) that might make this AP act the way it did prior to >> upgrading to 5.6.2? >> >> I’ve already tried every other 5 Ghz Frequency available (with a mix of >> different country codes), most with worse results. >> >> >> >> Thanks, >> >> Justin >> >> [email protected] >> >> >> > >
