Will there _*_ever_*_ be an option to just set the frames to a
particular dimension?
For example, go to AP x, set the parameters to whatever you need. You
run the frame calculator, and you get something like below:
*Modulation:FSK *
Total Frame Bits : 25000
*AP Details : *
Data Slots (Down/Up) : 23 +/9 +
Contention Slots: 7
Air Delay for Max Range: 54000 ns, 540 bits
Approximate distance for Max Range: 10.053 miles (53082 feet)
AP Transmit End : *15198*
AP Receive Start : *16280*
AP Receive End : 24921
Then I would like to go to _*_ANY_OTHER_AP_*_and tell it to match as
close as possible *AP Transmit End 15198 and AP Receive Start 16280*.
How hard would that be?
bp
<part15sbs{at}gmail{dot}com>
On 10/9/2015 12:44 PM, Sriram Chaturvedi wrote:
Hi Craig,
There is an offline frame calculator available to configure ePMP and
FSK for sync. It can be found here:
https://support.cambiumnetworks.com/files/epmp/ and is titled
"ePMP-PMP 100(FSK) Co-location Calculator”.
With your FSK settings below you can sync with ePMP with the following
settings according to the calculator:
Max Range: 16 (You can go lower or higher and still frame align but 16
works to match what you have now)
Downlink %: 75%
Ch BW: 20 MHz
Thanks,
Sriram
Join the Conversation
Cambium Networks Community Forum <http://community.cambiumnetworks.com>
On Oct 8, 2015, at 2:12 PM, Craig House <[email protected]
<mailto:[email protected]>> wrote:
I assumed that there was a way to make the EP MP stuff work with the
FSK stuff but I wasn't sure how to choose the right settings so that
sink would work what is the trick
We use 4 control slots 16 miles max distance and a 75% down link on
our FSK
Sent from my iPhone
On Oct 8, 2015, at 13:48, Josh Luthman <[email protected]
<mailto:[email protected]>> wrote:
Use ePMP and do what you were doing before. You can also match
settings so ePMP will sync with FSK.
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Thu, Oct 8, 2015 at 2:37 PM, Craig House
<[email protected] <mailto:[email protected]>> wrote:
What do you guys use for planning out tower sector RF ?? We
have always been a Cambium FSK shop and never really had to
worry much about self interference. Now with FSK end of life
and we are installing a lot more UBNT M series, we need to think
more about RF planning than we used to. Suggestions?
Craig
