Hi Craig, There is an offline frame calculator available to configure ePMP and FSK for sync. It can be found here: https://support.cambiumnetworks.com/files/epmp/ and is titled "ePMP-PMP 100(FSK) Co-location Calculator”.
With your FSK settings below you can sync with ePMP with the following settings according to the calculator: Max Range: 16 (You can go lower or higher and still frame align but 16 works to match what you have now) Downlink %: 75% Ch BW: 20 MHz Thanks, Sriram Join the Conversation Cambium Networks Community Forum<http://community.cambiumnetworks.com> On Oct 8, 2015, at 2:12 PM, Craig House <[email protected]<mailto:[email protected]>> wrote: I assumed that there was a way to make the EP MP stuff work with the FSK stuff but I wasn't sure how to choose the right settings so that sink would work what is the trick We use 4 control slots 16 miles max distance and a 75% down link on our FSK Sent from my iPhone On Oct 8, 2015, at 13:48, Josh Luthman <[email protected]<mailto:[email protected]>> wrote: Use ePMP and do what you were doing before. You can also match settings so ePMP will sync with FSK. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Thu, Oct 8, 2015 at 2:37 PM, Craig House <[email protected]<mailto:[email protected]>> wrote: What do you guys use for planning out tower sector RF ?? We have always been a Cambium FSK shop and never really had to worry much about self interference. Now with FSK end of life and we are installing a lot more UBNT M series, we need to think more about RF planning than we used to. Suggestions? Craig
