Upgrade will fix it I think. I think only 6.32.3 does this. 6.33 seems fine.
On Wed, Nov 18, 2015 at 1:35 PM, Adam Moffett <[email protected]> wrote: > I was wondering that exact thing. I'll find out tonight after a downgrade. > > > On 11/18/2015 2:33 PM, George Skorup wrote: > > What are the Tx and Rx power numbers when you're on 6.29? Maybe the DDM > data is supposed to be -4.117dBm/-1.745dBm and the older software is just > rounding it while the newer software is just stupid? > > I have two MT multimode SFPs in a CCR on 6.32.2 and they read fine: > > > On 11/18/2015 11:21 AM, Adam Moffett wrote: > > No.....nor does rebooting the router. I have several SFP's in at least 3 > CCR's with the same anomaly. Today just happens to be the first time I > noticed it, but I assume it's been like that for a little while. > > On 11/18/2015 12:03 PM, Josh Luthman wrote: > > You have an awesome noise floor in that light tunnel... > > Did restarting the interface fix the power readout? > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Wed, Nov 18, 2015 at 12:01 PM, Adam Moffett < <[email protected]> > [email protected]> wrote: > >> I have a few CCR's on 3.32.3 with the same model SFP in all of them. >> They're all showing screwball numbers for tx and rx power. >> >> With ROS 6.29, same model SFP, and same model CCR I get realistic >> numbers. I'm not sure if it's only some kind of a display artifact or a >> symptom of something worse, but this morning one of these SFP's stopped >> passing traffic and it started up again after I disabled and re-enabled it. >> >> I may drop back to 6.29 as precaution. I don't suppose anybody else has >> seen this on 6.32.3? >> >> >> >> >> > > > >
