Sterling, correct me if I'm wrong, but it's Plat about the most difficult system to setup, of all billing systems available on the wisp market? =)
On Thu, Dec 3, 2015 at 10:55 PM, Brett A Mansfield < [email protected]> wrote: > For me it's more about the time it takes to do it. There are aspects of > the install I cannot figure out. I asked them for deployment support and I > was told they don't offer it. Another guy told me he'd do it for more than > $2k. > > My current system just double, triple, or quadruple charged my autopay > customers for the third time. So I've shut down the gateway so it cannot do > it again. That's why I need something fast. None of my customers can pay > online right now. > > I'd prefer platypus, I just cannot get it working and have run out of > options to get it going. So I'm hoping someone has another option that > might work. > > Thank you, > Brett A Mansfield > > On Dec 3, 2015, at 11:44 PM, TJ Trout <[email protected]> wrote: > > Only quickly and easily if you are a experienced IT wizard, if your just a > dumb RF hand it's a insurmountable task > > On Thu, Dec 3, 2015 at 10:41 PM, Sterling Jacobson <[email protected]> > wrote: > >> Platypus can be deployed easily and quickly. >> >> Just pay them for the services to set it up etc. >> >> They don't cost much to do that. >> >> A few hundred dollars and you are completely up and running. >> >> Doesn't cost too much for licensing monthly either. >> >> >> >> -----Original Message----- >> From: Af [mailto:[email protected]] On Behalf Of Brett A Mansfield >> Sent: Thursday, December 3, 2015 11:36 PM >> To: [email protected] >> Subject: [AFMUG] Need new billing solution asap!!! >> >> I'm looking for a good billing solution that is cheap and I can have up >> in running immediately. >> >> I've had far too many issues with my current billing system. >> >> I need something turnkey and cheap. My WISP is a fairly small operation. >> >> I am not willing to pay per sub, especially if there is a minimum like >> visp. I don't want to buy any new hardware. I looked at platypus, but it >> cannot be deployed easily or quickly. I looked at powercode, but I don't >> want to buy any new hardware. >> >> Is there anything out there that might fit my needs? Or should I just go >> back to manual invoicing with quickbooks? >> >> Thank you, >> Brett A Mansfield >> > >
