Don't be a fool, wrap your... mount?
----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com Midwest Internet Exchange http://www.midwest-ix.com ----- Original Message ----- From: "Adam Moffett" <[email protected]> To: [email protected] Sent: Monday, January 11, 2016 2:11:19 PM Subject: Re: [AFMUG] Non Pen Mount Question +1 I've always worried about a burr or a sharp corner on the angle iron cutting a roof membrane.� I would never install without a rubber mat.....but I've seen it done by other people. On 1/11/2016 1:48 PM, Bill Prince wrote: Pretty much always use the rubber mats. Small protrusions (like the round head of a carriage bolt) is not normally an issue. Weld beads are OK too. bp <part15sbs{at}gmail{dot}com> On 1/11/2016 10:37 AM, Chuck McCown wrote: <blockquote> If the mount has the head of a carriage bolt coming though on the bottom, will this be a problem?� Now smooth does the bottom want to be?� Are weld beads OK. � Do you always use rubber mats under them? </blockquote>
