Ha....wear the glove parody. .. On Jan 11, 2016 1:14 PM, "Mike Hammett" <[email protected]> wrote:
> Don't be a fool, wrap your... mount? > > > > ----- > Mike Hammett > Intelligent Computing Solutions > http://www.ics-il.com > > <https://www.facebook.com/ICSIL> > <https://plus.google.com/+IntelligentComputingSolutionsDeKalb> > <https://www.linkedin.com/company/intelligent-computing-solutions> > <https://twitter.com/ICSIL> > > Midwest Internet Exchange > http://www.midwest-ix.com > > <https://www.facebook.com/mdwestix> > <https://www.linkedin.com/company/midwest-internet-exchange> > <https://twitter.com/mdwestix> > ------------------------------ > *From: *"Adam Moffett" <[email protected]> > *To: *[email protected] > *Sent: *Monday, January 11, 2016 2:11:19 PM > *Subject: *Re: [AFMUG] Non Pen Mount Question > > +1 > I've always worried about a burr or a sharp corner on the angle iron > cutting a roof membrane.� I would never install without a rubber > mat.....but I've seen it done by other people. > > > On 1/11/2016 1:48 PM, Bill Prince wrote: > > Pretty much always use the rubber mats. Small protrusions (like the round > head of a carriage bolt) is not normally an issue. Weld beads are OK too. > > bp > <part15sbs{at}gmail{dot}com> > > > On 1/11/2016 10:37 AM, Chuck McCown wrote: > > If the mount has the head of a carriage bolt coming though on the bottom, > will this be a problem?� Now smooth does the bottom want to be?� Are > weld beads OK. > � > Do you always use rubber mats under them? > > > > >
