When the sleeve pops off, you just use vinyl tape to keep it on. Lots of tape.
From: That One Guy /sarcasm Sent: Wednesday, February 03, 2016 12:03 PM To: [email protected] Subject: Re: [AFMUG] weird problem tighten it til the sleeve pops off, cuss, put a new end on and tighten it just a little less. There is probably a torque rating On Wed, Feb 3, 2016 at 12:41 PM, Chuck McCown <[email protected]> wrote: Compressing the rubber gasket. From: Ken Hohhof Sent: Wednesday, February 03, 2016 11:38 AM To: [email protected] Subject: Re: [AFMUG] weird problem How tight is “fully tight”? I was taught hand tightened or equivalent, rather than put a wrench on it and crank it until it bottoms out. Is that wrong? SMA connectors seem to have a more pronounced stop when they’re tight. From: Chuck McCown Sent: Wednesday, February 03, 2016 12:35 PM To: [email protected] Subject: Re: [AFMUG] weird problem Yeah, it is interesting to watch a N connector on a network analyzer set for return loss/VSWR/reflection coefficient. It gets better with every turn and keeps on improving right up to the last bit of movement. Anything less than fully tight is causing a problem. From: Sean Heskett Sent: Wednesday, February 03, 2016 11:30 AM To: [email protected] Subject: Re: [AFMUG] weird problem 3/4 of a turn on an N connector is a lot. You were probably loosing a lot of RF out that port. On Wednesday, February 3, 2016, Dan Petermann <[email protected]> wrote: We have two 11GHz links on the same freqs. One V and one H pol. These are dual links, 2 - 40Mhz channels. The radios are Dragonwave, one Quantum and the other a Horizion Duo. We had to replace the IDU of the Quantum with a DUO and put the link into DUO compatibility mode. After replacing the IDU, we started having issues on the other link. The RX levels of one freq dropped by 9dBm, the equalizer stress jumped to 150 (should be under 100), and the link would only run at 32QAM. This morning I moved the IDU up 1 RU (it was sitting directly onto of the other IDU) and tightened the coax by 3/4 of a turn. Gained 9dB, lowered equalizer stress by 50, and now running at 256QAM. I check the IF freqs and they were separated by 200MHz. I’m curious, does anyone have an idea why this happened? -- If you only see yourself as part of the team but you don't see your team as part of yourself you have already failed as part of the team.
