"So if 180Mbps of traffic suddenly becomes 40Mbps of traffic, and 5 percent packet loss to the gateway on the other side, we should see that same ping loss to the management IP of the radio on the other side of the link as well, correct?"
Correct. On Fri, Feb 12, 2016 at 12:21 PM, Sterling Jacobson <[email protected]> wrote: > Ok. > > > > We are not using 802.1p. > > > > So if 180Mbps of traffic suddenly becomes 40Mbps of traffic, and 5 percent > packet loss to the gateway on the other side, we should see that same ping > loss to the management IP of the radio on the other side of the link as > well, correct? > > > > > > > > *From:* Af [mailto:[email protected]] *On Behalf Of *Chuck Macenski > *Sent:* Friday, February 12, 2016 11:13 AM > *To:* [email protected] > *Subject:* Re: [AFMUG] Airfiber Management Priority? > > > > Hi, > > > > Actually, airFiber does prioritize packets based on 802.1p (VLAN header > priority). If you aren't using this, then, everything is at the same > prioirity. > > > > Chuck > > > > On Fri, Feb 12, 2016 at 11:46 AM, Josh Reynolds <[email protected]> > wrote: > > This is very very wrong. > > AirFiber does not prioritize any data, it is a dumb bridge. > > If you are not dropping pings across the link, then its not the AirFiber. > > Now, there could be packet reordering going on due to noise or > instructions that would cause certain issues for VOIP etc that would not > show up with a ping. > > On Feb 12, 2016 11:19 AM, "Josh Luthman" <[email protected]> > wrote: > > Possible, yes. If you look at those brochures and flyers they all talk > about traffic priority during de-modulation. > > > I don't know if AF does it, though. If ICMP exceeds TCP/UDP/etc priority > I don't know either, but on licensed links it's usually configurable. > > > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > > > On Fri, Feb 12, 2016 at 12:15 PM, Sterling Jacobson <[email protected]> > wrote: > > Is it possible to have traffic cut down to 30-40Mbps on an Airfiber 24GHz > link due to modulation, with packet loss, but still be able to ping across > the link with zero packet loss? > > > > >
