If you want a graph, then you don't want to make a probe. You create
probes to check for the up/down status of something so that you can get
an alert about it.
Look under charts, add the value you're trying to get as a data source,
and add the data source to the chart.
On 2/23/2016 1:16 AM, Jason McKemie wrote:
How do you set up the SNMP probe? When I set up the type as "SNMP" I
can only seem to get it to graph the response time of the SNMP query
and not the data itself.
On Mon, Feb 22, 2016 at 3:23 AM, Adam Moffett <[email protected]
<mailto:[email protected]>> wrote:
4.0b3
I also am not using a "function" probe type anywhere. I do use
the SNMP probe type extensively.
On 2/22/2016 1:52 AM, Jason McKemie wrote:
Upon searching in the Mikrotik Forums, it looks like this could
be an issue with custom OIDs on the newer versions of the dude.
What version are you using?
On Sat, Feb 20, 2016 at 8:29 PM, Adam Moffett
<[email protected] <mailto:[email protected]>> wrote:
Try
oid_raw("1.3.6.1.4.1.32050.2.1.27.5.0")
I'm not totally sure what the difference is, other than
sometimes that one works.
On 2/20/2016 8:14 PM, Jason McKemie wrote:
I've just started working with using the Dude for
monitoring on the bench, but I'm getting a parse failed
on the probe for a test device. I've attached an image
showing the function and probe I created. Any ideas what
I'm doing wrong? Please note that this is just a test
setup using a Ubiquiti AP with no client. I'm aware that
the noise floor reading is essentially useless and have
no intention of graphing it in a production environment.
-Jason
