That would be my question too. Were the adjacencies up full at the time and not stuck in 2-way or something like that? If they were full but no traffic, my money would be on OSPF routes simply not getting injected into the routing table.

Pretty much all of my OSPF issues went away after moving from 5.25/26 to 6.32.2. However, I did have a similar situation a week or so ago. No traffic across a link for several hours. And the link was definitely up. It happened in the middle of the night, so I didn't get a chance to see what was going on. It just fixed itself. But the routers showed no adjacency loss. So I have no idea.

On 2/28/2016 10:50 AM, Darin Steffl wrote:
Have you checked to see if there is still an OSPF connection running over this licensed link? As in do you see the neighbor router listed in OSPF for the other side of the link?

On Sun, Feb 28, 2016 at 10:18 AM, Adam Moffett <[email protected] <mailto:[email protected]>> wrote:

    I have a 500mbps licensed microwave path that was up and looking
    perfectly fine, but had no traffic on it.
    Instead traffic was moving on a 5.8 Radwin to a different site.
Everything was up, but I don't understand this route selection. The path via the Radwin is longer to lots of places, so OSPF
    should have used the licensed path for at least SOME traffic
    simply based on it being shorter.  I also set the costs on the
    interfaces on both ends of that Radwin to 150, so it normally
    doesn't get used at all. Somehow this morning at 3:15am the
    routers decided to use the backup path.  Everything returned to
    normal after I rebooted one end.

    It may be coincidental (or not), but I know a truck took out a
    telephone pole last night which caused an upstream fiber issue,
and we had a UPS battery explode. Is this all coincidence? Sometimes UPS's explode, sometimes That One Guy Steve burns down a
    house, sometimes RouterOS rides the short bus, some things are
    just outside our control.  Or maybe a truck hit a pole, which
    caused a power surge that blew up a UPS and made a Mikrotik fart
    inside of it's head. I could believe either one.

    In any case.  Is there a different RouterOS version that will
    trust my opinion when I tell it a path has high cost? Currently
    running 6.32.3 I think.  It's pretty non-sensical that this
    happened at all.




--
Darin Steffl
Minnesota WiFi
www.mnwifi.com <http://www.mnwifi.com/>
507-634-WiFi
<http://www.facebook.com/minnesotawifi> Like us on Facebook <http://www.facebook.com/minnesotawifi>

Reply via email to