Put a neoprene washer under the bolt, and a bead of silicone behind the
strut. Even if it someday down the road it started weeping during the
rain it would just fall out through your condensate drain.
.....I didn't read your parts list though. If you /don't/ have a
condensate drain you should think about that.
On 4/28/2016 12:40 PM, Scott Vander Dussen wrote:
Yeah I feel the same. The two are going into reinforced embedded threads-
adding more would mean a penetration to the box :/ maybe JB weld the strut on
there too!
Thanks,
`S
---
Sent mobile, typed by thumbs.
On Apr 28, 2016, at 09:37, Adam Moffett <[email protected]> wrote:
Very nice.
Just an opinion, but I would put a few more bolts into that mounting strut.
I'm guessing you've got one in each corner. Even low grade steel bolts are
staggeringly strong, but if you had a bad one then suddenly you're hanging on
one bolt.
On 4/27/2016 8:54 PM, Scott Vander Dussen wrote:
I built a CMM for 2016!
Highlights:
* Gigabit everything
* BiDi fiber support for 6 devices
* Sync/Power up to 24 devices
* Power 24v and 48v devices
* Temperature monitoring
* Fan ventilation controlled by rain/condensation sensor
* Fan seizure notification
* LED light strip controlled by door
* Door alarm trigger
* Hoist pull loop
* 20" x 18" x 10"
* 36lbs
* Price circa $2100
Photo here: https://dl.dropboxusercontent.com/u/6582330/WebJunk/SMM.jpg
Parts list here:
https://dl.dropboxusercontent.com/u/6582330/WebJunk/SMM%20Details.pdf
Any suggestions to make this more awesome?
[http://www.flutecrate.com/uploads/1/0/2/0/10200817/5243300_orig.jpg]
