Is there any hardware acceleration at all if you use bridges? My needs
are actually pretty simple with this switch, but I do need it to move a
few hundred megs.
If bridging turns out to not be fast enough, and RSTP isn't available as
a switch, then do I have any fallback option? Port isloation? VLAN's?
I feel like a simple job just became a hard one.
On 5/2/2016 12:07 PM, Ken Hohhof wrote:
I see it in the Bridge menu but not the Switch menu. I'm guessing you
don't want to do your switching in software, especially since some of
the CRS models have underpowered CPUs on the assumption most of the
traffic will be switched in the switch chips.
I wonder if the switch chips don't support STP, or Mikrotik just
hasn't written the firmware to enable it.
-----Original Message----- From: Adam Moffett
Sent: Monday, May 02, 2016 10:34 AM
To: [email protected]
Subject: [AFMUG] Mikrotik CRS - prevent loop
Does the CRS really not do RSTP? I can't find it in Winbox, and I read
some forum posts suggesting that it isn't there.
What other methods do I have available to prevent an accidental loop?
