without buying one to physically check would there be a way to know if our
leviton keystones fit that

On Fri, May 20, 2016 at 5:49 PM, Eric Kuhnke <[email protected]> wrote:

> If it has to be under $200 or near it with no holes, you drill them out
> yourself and install glands/conduit, this:
>
>
> http://www.l-com.com/nema-enclosures-18x16x8-inch-weatherproof-nema-enclosure-with-mounting-plate
>
> consider doing it as two surface mounted 12-port keystone patch panels on
> the aluminum backplate, rather than a 1U 24-port patch panel.
>
> such as,
> http://www.showmecables.com/product/Keystone-Blank-Patch-Panel-High-Density-Style-12-Port.aspx
>
>
>
>
>
> On Fri, May 20, 2016 at 3:38 PM, That One Guy /sarcasm <
> [email protected]> wrote:
>
>> I need a small enclosure to house a 1u 24 port patch panel (we normally
>> sick 3U minimum in a box)
>> this will need to allow for up to 48 cable entries if the whole thing
>> were populated. This is for the top of a grain elevator (will use the same
>> set up elsewhere)
>>
>> We bring BBDGE up to it and terminate to the panel, then as we add radios
>> we just add the tail, we will bond the copper shields in here too. We do
>> individual 1/2 inch knockout entries.
>>
>> It just needs to stand up in wind and sun, we will put all the holes in
>> it. I do meed to keep the weight down because it will probably end up
>> mounted to the site 1 1/2 inch conduit
>>
>> Im looking for inexpensive (sub 200$) no removable gaskets for techs to
>> drop part numbers. I know all the vendors websites, Im looking for
>> something somebody else has used. It doesnt even have to be this same
>> design, just a cross connect box that we can change the top end tails
>> easily. need part numbers here
>>
>>
>>
>> --
>> If you only see yourself as part of the team but you don't see your team
>> as part of yourself you have already failed as part of the team.
>>
>
>


-- 
If you only see yourself as part of the team but you don't see your team as
part of yourself you have already failed as part of the team.

Reply via email to