I think there are a couple of products geared towards high throughput to
a small number of stations.
Radwin Jet is supposed to do 750mbps using 80mhz...or something like
that.
Knowing Radwin....it's probably an 802.11ac chipset under the hood.
------ Original Message ------
From: [email protected]
To: [email protected]
Sent: 7/22/2016 11:31:03 AM
Subject: Re: [AFMUG] Over subscription Rate
I would be giving everyone 25 Mbps if I was to put it up. So, I doubt
I could put more than about 6 on there without running into trouble.
From:Kurt Fankhauser
Sent: Friday, July 22, 2016 9:13 AM
To:[email protected]
Subject: Re: [AFMUG] Over subscription Rate
With the Cambium PMP450 I monitor the framelink utilization via SNMP to
determine if an AP is oversubscribed or not. I have 25 subs on this ap
and it peaks at about 25% utilization on the downlink every night.
Customers are a mix of 1.5Meg / 3.0Meg / 6Meg download with up to
20mbps bursting. At this rate I would safely say I could put 75
subscribers on this AP but it really is dependent on who your customers
are. I have a similar AP only serving 15 customers that will hit 50%
utilization sometimes. Apparently the customers in that area must watch
more Netflix, lol.
On Fri, Jul 22, 2016 at 9:21 AM, Sam Morris <[email protected]> wrote:
Very helpful Adam. Thank you!
Sam
On 7/21/2016 4:18 PM, Adam Moffett wrote:
I don't believe in over subscription rates. :)
For planning purposes, I assume we'll get 2/3's of advertised
throughput
from the AP and then plan on 8:1.
In real life you have to abandon the over subscription rate after the
planning phase and monitor what's actually happening on the AP's.
Averaging hundreds of users together you'll get actual usage that
seems
in line with an 8:1 or 6:1 ratio. On an individual AP you tend to not
have enough capacity for more than 30-50 people, so you can easily
get a
few statistical outliers in the mix that make actual consumption not
line up with the planned over subscription rate.
It goes both ways too....I've seen sites with actual over
subscription
of 20:1 and everything's working ok, and other actual sites fall
apart
when oversub was only 4:1.
------ Original Message ------
From: "Sam Morris" <[email protected]>
To: [email protected]
Sent: 7/21/2016 7:58:18 AM
Subject: [AFMUG] Over subscription Rate
At what level do you over subscribe your APs? 4:1? 8:1? 15:1? Or
something else?
Thanks
Sam
