I think he might have been pointing out that if your installer didn’t know 
about the 2 degree downtilt, it could have been installed with too much 
downtilt which would adversely affect performance comparisons.

Also look at the elevation plots for the 2 products, the Cambium sector is 
shown as having quite a bit of null fill.

Electrical downtilt could also be more consistent at the edges of the sector 
than mechanical downtilt.

RF Elements in their literature touts matching VPOL and HPOL patterns, 
obviously good for MIMO-B performance.  Those of us who have tried dual pol 
omnis know the downside of mismatched VPOL and HPOL antenna gain.


From: Jaime Solorza 
Sent: Monday, August 15, 2016 4:43 PM
To: Animal Farm 
Subject: Re: [AFMUG] RF Elements vs. Cambium sectors

Use a washer... Zaz 2 degree downtilt.  Lol


On Aug 15, 2016 3:25 PM, "Faisal Imtiaz" <[email protected]> wrote:

  Sitting back and just comparing the specs, I can believe the results.
  Both are excellent sectors, but if you do a line by line spec comparison you 
will see that RF Elements eeks out by a notch.

  The only thing to keep in mind is that Cambium is showing 2degree electrical 
down-tilt, and Rf Element does not have that.


  Regards.

  Faisal Imtiaz
  Snappy Internet & Telecom
  7266 SW 48 Street
  Miami, FL 33155
  Tel: 305 663 5518 x 232

  Help-desk: (305)663-5518 Option 2 or Email: [email protected]


------------------------------------------------------------------------------

    From: "Paul McCall" <[email protected]>
    To: [email protected]
    Sent: Monday, August 15, 2016 2:16:34 PM
    Subject: [AFMUG] RF Elements vs. Cambium sectors

    I saw an interesting set of test results or someone testing an ePMP 1000 
with RF Elements 17 db sector vs. Cambium ePMP 2000 with Cambium 2000 sector, 
and the performance was actually better with RF elements.  Yet, Cambium’s new 
sector claims 35dB F/B vs. 29dB for RF Elements.



    Anybody using RF Elements sector with ePMP 1000 radios and getting good 
results on F/B GPS Sync issues?  I know with the 1000 series, we needed 8 to 15 
feet of vertical separation to make everything run smooth on Frequency re-use.  
It will “work” with less.



    Anyway, curious if that will be a problem with RF Elements in the same 
environment.  I see RF elements has some bigger gain sectors as well.



    Paul McCall, President

    PDMNet, Inc. / Florida Broadband, Inc.

    658 Old Dixie Highway

    Vero Beach, FL 32962

    772-564-6800 

    [email protected]

    www.pdmnet.com

    www.floridabroadband.com







Reply via email to