Are you sure it's a connectorized Sync radio?
On 8/30/2016 10:39 AM, Chuck McCown wrote:
I get no lights on the AP.
*From:* Josh Baird <mailto:[email protected]>
*Sent:* Tuesday, August 30, 2016 9:26 AM
*To:* [email protected] <mailto:[email protected]>
*Subject:* Re: [AFMUG] Powering ePMP
Netonix will power GPS sync ePMP models just fine on 24V or 48V, but
we run them all at 48V due to the cold-temp in-rush problems that
occurred in early ePMP firmware.
On Tue, Aug 30, 2016 at 11:22 AM, Chuck McCown <[email protected]
<mailto:[email protected]>> wrote:
It appears, due to the polarity, this cannot be done.
Netonix does not have an option to put positive on 7&8.
So I need to figure out how to put it in a POE passive pass
through mode it appears.
*From:* Jordan Gregory <mailto:[email protected]>
*Sent:* Tuesday, August 30, 2016 9:19 AM
*To:* [email protected] <mailto:[email protected]>
*Subject:* Re: [AFMUG] Powering ePMP
Just the standard 48V. 24 isn't enough and the 4pin 48VH isn't
necessary.
On Aug 30, 2016 10:16 AM, "Chuck McCown" <[email protected]
<mailto:[email protected]>> wrote:
It has the GPS puck but I have not connected it yet. Just
playing.
What Netonix poe setting do you use?
*From:* Jordan Gregory <mailto:[email protected]>
*Sent:* Tuesday, August 30, 2016 9:15 AM
*To:* [email protected] <mailto:[email protected]>
*Subject:* Re: [AFMUG] Powering ePMP
GPS synced or not?
My ePMP 1000 w/ GPS are being powered by a netonix. SMs don't
work though.
On Aug 30, 2016 10:11 AM, "Chuck McCown" <[email protected]
<mailto:[email protected]>> wrote:
When powering an ePMP, I notice that the power supply from
Cambium shows 7&8 positive, 4&5 return.
Is it not possible to power it directly from a Netonix
WS-12-DC?
