It supports telnet and SSH.
I remember having a bit of a time trying to install Net::SSH on the machine I
need to run this on so I haven’t tried that yet.
I actually just figured out if I set $t->errmode("return"); and have a 60
second timeout, my script now makes it all the way through.
Just wish I could do this via SNMP so it would run in under 1-2 seconds as
opposed to 1.5-2 minutes.
Thanks,
Justin
From: Af [mailto:[email protected]] On Behalf Of Cameron Crum
Sent: Monday, November 07, 2016 3:01 PM
To: [email protected]
Subject: Re: [AFMUG] UBNT S16 SNMP or Net::Telnet ....
Does it support straight Telnet? Have you tried Net::SSH2?
On Mon, Nov 7, 2016 at 1:46 PM, Justin Marshall
<[email protected]<mailto:[email protected]>> wrote:
Hi,
I’m looking for the SNMP OID’s for POE config on the UBNT EdgePoint S16.
Specifically the ones that would let you disable/enable passive24v on a
specific port.
I tried an snmpwalk, but without a MIB there’s a lot to dig through.
I actually found a thread on UBNT’s forums that say you have to retrieve them
from the filesystem itself
(https://community.ubnt.com/t5/EdgeMAX/SNMP-MIB-File/td-p/464763), but can’t
figure out how to actually get at the filesystem. SSH & Telnet both yield
“(UBNT EdgeSwitch) (Config)#” prompts with no real way to get underneath
(unless it’s so obvious I’m just somehow missing it)
Can anyone point me in the right direction?
If not… Has anyone had luck with Net::Telnet and the Edgepoint S16? I’ve not
been able to get a script to get past “configure” (nothing but timeouts, even
when matching the specific prompt)
Thanks,
Justin
[email protected]<mailto:[email protected]>
