Yep, I noticed that too back on 14.1.2 and forgot to tell Cambium about
it. If the carrier frequency is set to None, the SA will not run. You
can try clicking the continuous spectrum analysis button below the timed
button and see if that works, but I don't think it does either if freq =
None.
On 12/21/2016 3:46 PM, Darin Steffl wrote:
Hello,
I'm following in the manual on how to initiate a timed spectrum scan.
I enter 30 seconds and then click "Start Timed Sector Spectrum Analysis"
The problem is that nothing on this page changes. The results box at
the top still shows "Spectrum Analysis not performed". I've rebooted
the radio, updated to the latest 15.0.2 firmware and still no go.
I'm following step-by-step in the 723 page manual and not having good
luck getting the spectrum analyzer to do anything for me.
I'm in Chrome and maybe that's the problem. Any advice on how to get
this working? This is our first 450 radio so please bear with us. It
took me 10 mins to figure out CNUT and how to upgrade firmware. I was
expecting to upgrade via the GUI like ePMP and Ubiquiti ha
Thanks
--
Darin Steffl
Minnesota WiFi
www.mnwifi.com <http://www.mnwifi.com/>
507-634-WiFi
<http://www.facebook.com/minnesotawifi> Like us on Facebook
<http://www.facebook.com/minnesotawifi>
