I just ran a 30 second timed scan on a 900 450i sector running 14.2.1. 6
SMs registered. Worked fine. So.... I have no idea.
On 12/21/2016 3:56 PM, Darin Steffl wrote:
We have Frequency carrier set to 907 mhz currently so it is not on NONE.
On Wed, Dec 21, 2016 at 3:52 PM, George Skorup <[email protected]
<mailto:[email protected]>> wrote:
Yep, I noticed that too back on 14.1.2 and forgot to tell Cambium
about it. If the carrier frequency is set to None, the SA will not
run. You can try clicking the continuous spectrum analysis button
below the timed button and see if that works, but I don't think it
does either if freq = None.
On 12/21/2016 3:46 PM, Darin Steffl wrote:
Hello,
I'm following in the manual on how to initiate a timed spectrum
scan. I enter 30 seconds and then click "Start Timed Sector
Spectrum Analysis"
The problem is that nothing on this page changes. The results box
at the top still shows "Spectrum Analysis not performed". I've
rebooted the radio, updated to the latest 15.0.2 firmware and
still no go.
I'm following step-by-step in the 723 page manual and not having
good luck getting the spectrum analyzer to do anything for me.
I'm in Chrome and maybe that's the problem. Any advice on how to
get this working? This is our first 450 radio so please bear with
us. It took me 10 mins to figure out CNUT and how to upgrade
firmware. I was expecting to upgrade via the GUI like ePMP and
Ubiquiti ha
Thanks
--
Darin Steffl
Minnesota WiFi
www.mnwifi.com <http://www.mnwifi.com/>
507-634-WiFi
<http://www.facebook.com/minnesotawifi> Like us on Facebook
<http://www.facebook.com/minnesotawifi>
--
Darin Steffl
Minnesota WiFi
www.mnwifi.com <http://www.mnwifi.com/>
507-634-WiFi
<http://www.facebook.com/minnesotawifi> Like us on Facebook
<http://www.facebook.com/minnesotawifi>
