I realize this doesn’t answer your torque question, but are you using the Cambium yagi with the silicone rubber boots that push down over the connector? If so, I don’t think you are supposed to tape them.
From: Af [mailto:[email protected]] On Behalf Of Chuck McCown Sent: Tuesday, February 28, 2017 5:13 PM To: [email protected] Subject: Re: [AFMUG] PMP450 900mhz SM RP-SMA connectors nut torque I would hope that some kind of standardized torque is used. From: Colin Stanners Sent: Tuesday, February 28, 2017 3:10 PM To: [email protected] <mailto:[email protected]> Subject: [AFMUG] PMP450 900mhz SM RP-SMA connectors nut torque The PMP450 900mhz SM has the connectors on top of the radio, which worries me in terms of water ingress (can't really rubber tape the connector-case area) One the first SM I tried, the nuts that tighten the weatherproofing were a bit loose - does anyone know how tight to put them? Don't want it too tight that it breaks solder on the connections after a few years of temperature cycling.
